Bazooka MGA11500H manual Power Connections MGA11000H, English

POWER CONNECTIONS MGA11000H

1	CHIL	+12V TURN-ON GND
MIN		FUSE 30A X 4

ENGLISH

IN-LINE POWER FUSE

MOUNTED WITHIN 6”

FROM BATTERY RECOMMENDED

(NOT PROVIDED)

RADIO'S REMOTE

TURN-ON OUTPUT

94.7

+-

CAR BATTERY

+12V

IMPORTANT! Before making any connections, disconnect the car’s battery until the installation is completed to avoid possible damage to the electrical system.

Connect the amplifier to the car's battery.

Make your power connections using a 4 gauge power wire for your connections. Strip one end of the wire to connect to the terminal on the amplifier marked “+12V”. Loosen screw terminal and connect bare wire and tighten. Use caution to make sure no stray wire strands come in contact with surrounding terminals causing short circuits. Run the wire directly to the positive terminal of the car's battery. Make sure to use an in-line fuse within 6” of the car's battery to protect the electrical system and amplifier against short circuits and/or power surges.

Connect the ground terminal of the amplifier to the car's chassis.

For the ground connection, use an 4 gauge wire (black) to connect to the terminal marked GND and then connect it to the car's chassis. Try to keep the length of the cable as short as possible, preferably less than 6". Also make sure that the point on the car where the connection is to be made is free of paint and dirt.

Connect the remote terminal of the amplifier to a switchable +12V source.

This connection allows the amplifier to be turned on and off with the power control of the radio. If the radio has a REMOTE output terminal, connect it to the amplifier's terminal marked “TURN-ON” (using a 16 gauge wire or heavier). Now when the radio is turned on, the amplifier will automatically turn on.

8 MGA AMPLIFIERS