Eclipse - Fujitsu Ten D2140 technical manual Installation, Driver installation

Page 16

Brief instructions on installing mainboard

Installation

Equip the mainboard with the processor, heat sink and memory modules before installation if possible. Further information can be found in "Replacing the processor" chapter.

► Open the casing as described in the operating manual.

► Should no suitable connection field be provided in the case, then you must install the connection field (1) provided.

Ensure the plate is aligned properly so that the connections are suitable for the mainboard later.

► Set the mainboard on the edge on which the connection field is located (2) and then insert the board in the

case (3).

Make sure that spacers in the housing are only mounted at points at which there are mounting holes in the mainboard.

► Fasten the mainboard with the screws.

Connect the plugs for the power supply, control panel and drives to the corresponding connections on the mainboard.

Driver installation

Install the drivers for the chipset. You may find the driver on the "Drivers & Utilities" CD. Please refer to chapter "Drivers" for a description of installing drivers.

A26361-D2140-Z120-1-7419, edition 1

English - 7

Image 16
Contents Answers2 EnglishSie haben Page A26361-D2140-Z120-1-7419 Technisches Handbuch Technical Manual Mainboard D2140Ausgabe November November 2004 edition Page Übersicht/Overview Mainboard D2140 LEDContents Page Notational conventions Additional informationImportant notes Information about boardsOnboard features List of featuresSpecial onboard features Internal ports External portsSpecial features Brief instructions on installing mainboard Prior to installationInstallation Driver installationInterfaces and connectors External portsLAN port LED 1 greenInternal ports and connectors Or 6-channel audio mode via analogue audio channelsHard disk connection Audio front panelUsing external audio connections Selecting settings for 2, 4 or 6-channel audio modeAnalogue 2-channel audio output Analogue 4-channel audio outputFront panel Pin assignment of internal portsUSB dual channel Floppy interface ATA interface Power supply BTX Additional power supply ATX12Settings with switches and jumpers Setting via control-panel plug connectorSkipping system and Bios Setup password pinpair a Recovering System Bios pinpair BInstalling processor with heat sink Technical dataAdd-on modules / Upgrading Replacing the processorReplacing the processor Mounting heat sink Installing a memory module Upgrading main memoryAdding PCI cards Removing a memory moduleAudio Modem PCI bus interrupts Selecting correct PCI slotMonofunctional expansions cards Replacing the lithium battery When should a Bios update be carried out? Bios updateBios update under Windows with DeskFlash utility Bios Recovery Recovering System Bios What is a microcode update? Microcode UpdateWhen should a microcode update be carried out? Drivers Error messages Bios update for installed CPU failedError messages Missing or invalid Nvram token System battery is dead Replace and run Setup Glossary