Eclipse - Fujitsu Ten D2140 technical manual Mounting heat sink

Page 27

Replacing the processor

Mounting heat sink

Be sure to use heat conducting material between the processor and the heat sink. If a heat conducting pad (rubber-like foil) is already applied to the heat sink, then use it. Otherwise you must apply a very thin layer of heat conducting paste.

Heat conducting pads can only be used once. If you remove the heat sink, you must clean it and apply new heat conducting paste before you remount it.

Please note that, depending on the heat sink used, different heat sink mounts are required on the mainboard.

1

2

2

2

2

Depending on the configuration variant, you must pull a protective foil off the heat sink or coat the heat sink with heat conducting paste before fitting it.

Secure the heat sink - depending on the model - with four screws or push it into the mounts.

18 - English

A26361-D2140-Z120-1-7419, edition 1

Image 27
Contents English Answers2Sie haben Page A26361-D2140-Z120-1-7419 Mainboard D2140 Technisches Handbuch Technical ManualAusgabe November November 2004 edition Page LED Übersicht/Overview Mainboard D2140Contents Page Additional information Notational conventionsInformation about boards Important notesList of features Onboard featuresSpecial onboard features External ports Internal portsSpecial features Prior to installation Brief instructions on installing mainboardDriver installation InstallationLED 1 green Interfaces and connectorsExternal ports LAN portAudio front panel Internal ports and connectorsOr 6-channel audio mode via analogue audio channels Hard disk connectionAnalogue 4-channel audio output Using external audio connectionsSelecting settings for 2, 4 or 6-channel audio mode Analogue 2-channel audio outputPin assignment of internal ports Front panelUSB dual channel Floppy interface ATA interface Additional power supply ATX12 Power supply BTXRecovering System Bios pinpair B Settings with switches and jumpersSetting via control-panel plug connector Skipping system and Bios Setup password pinpair aReplacing the processor Installing processor with heat sinkTechnical data Add-on modules / UpgradingReplacing the processor Mounting heat sink Upgrading main memory Installing a memory moduleRemoving a memory module Adding PCI cardsPCI bus interrupts Selecting correct PCI slot Audio ModemMonofunctional expansions cards Replacing the lithium battery Bios update When should a Bios update be carried out?Bios update under Windows with DeskFlash utility Bios Recovery Recovering System Bios Microcode Update What is a microcode update?When should a microcode update be carried out? Drivers Bios update for installed CPU failed Error messagesError messages Missing or invalid Nvram token System battery is dead Replace and run Setup Glossary