Eclipse - Fujitsu Ten D2140 technical manual Error messages

Page 37

Error messages

DMA test failed

EISA CMOS not writable

Extended RAM Failed at offset: nnnn

Extended RAM Failed at address line: nnnn

Failing Bits: nnnn

Fail-Safe Timer NMI failed

Multiple-bit ECC error occurred

Memory decreased in size

Memory size found by POST differed from EISA CMOS

Single-bit ECC error occurred

Software NMI failed

System memory exceeds the CPU’s caching limit

System RAM Failed at offset: nnnn

Shadow RAM Failed at offset: nnnn

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

Failure Fixed Disk 0

Failure Fixed Disk 1

Fixed Disk Controller Failure

Check the entry for the hard disk drive in the Main menu and the entry for the IDE drive controller in the Advanced - Peripheral Configuration menu of the BIOS Setup. Check the hard disk drive's connections and jumpers.

Incorrect Drive A - run SETUP

Incorrect Drive B - run SETUP

Correct the entry for the diskette drive in the Main menu of the BIOS Setup.

Invalid NVRAM media type

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

Invalid System Configuration Data

In the Advanced menu of the BIOS Setup set the entry Reset Configuration Data to Yes.

Invalid System Configuration Data - run configuration utility Press F1 to resume, F2 to Setup

This error message may be displayed if the machine was switched off during system start-up.

Call BIOS Setup and switch to the Advanced menu. Select the menu item Reset Configuration Data and change the setting to Yes. Save the change and terminate BIOS Setup. Reboot the device.

Keyboard controller error

Connect another keyboard or another mouse. If the message is still displayed, please contact your sales outlet or customer service centre.

Keyboard error

Check that the keyboard is connected properly.

Keyboard error nn nn Stuck Key

Release the key on the keyboard (nn is the hexadecimal code for the key).

28 - English

A26361-D2140-Z120-1-7419, edition 1

Image 37
Contents English Answers2Sie haben Page A26361-D2140-Z120-1-7419 Technisches Handbuch Technical Manual Mainboard D2140Ausgabe November November 2004 edition Page LED Übersicht/Overview Mainboard D2140Contents Page Additional information Notational conventionsInformation about boards Important notesOnboard features List of featuresSpecial onboard features External ports Internal portsSpecial features Prior to installation Brief instructions on installing mainboardDriver installation InstallationExternal ports Interfaces and connectorsLAN port LED 1 greenOr 6-channel audio mode via analogue audio channels Internal ports and connectorsHard disk connection Audio front panelSelecting settings for 2, 4 or 6-channel audio mode Using external audio connectionsAnalogue 2-channel audio output Analogue 4-channel audio outputFront panel Pin assignment of internal portsUSB dual channel Floppy interface ATA interface Additional power supply ATX12 Power supply BTXSetting via control-panel plug connector Settings with switches and jumpersSkipping system and Bios Setup password pinpair a Recovering System Bios pinpair BTechnical data Installing processor with heat sinkAdd-on modules / Upgrading Replacing the processorReplacing the processor Mounting heat sink Upgrading main memory Installing a memory moduleRemoving a memory module Adding PCI cardsAudio Modem PCI bus interrupts Selecting correct PCI slotMonofunctional expansions cards Replacing the lithium battery When should a Bios update be carried out? Bios updateBios update under Windows with DeskFlash utility Bios Recovery Recovering System Bios What is a microcode update? Microcode UpdateWhen should a microcode update be carried out? Drivers Bios update for installed CPU failed Error messagesError messages Missing or invalid Nvram token System battery is dead Replace and run Setup Glossary