Eclipse - Fujitsu Ten D2140 technical manual Internal ports and connectors, Hard disk connection

Page 18

Internal ports and connectors

Internal ports and connectors

The positions of the internal ports and connectors are shown on the Cover. Additional information on some ports is also provided here.

Hard disk connection

An ultra ATA/66 or ultra ATA/100 hard disk must be connected with a cable especially designed for the ultra ATA/66 or ultra ATA/100 mode.

Connect the end of the cable marked with blue to the mainboard.

Audio front panel

If you want to use the internal connection for the audio front panel for the front side of the system, then proceed as follows:

Remove all plug-in jumpers from the audio front panel connection.

Connect the cable for the audio front panel.

i

If you connect audio devices on both the front and the back of the system, you can only

use the connections Line out and Microphone once each.

If you have connected audio devices to both Line out connections, only the connection on the front of the system is active.

If you have connected audio devices to both Microphone connections, only the connection on the back of the system is active.

2, 4 or 6-channel audio mode via analogue audio channels

The mainboard supports a 6-channel audio output via the analogue audio channels (2 front, 2 rear, 1 centre and 1 subwoofer channel). This makes it possible to connect 4 or 6 loudspeakers, and therefore to achieve a better surround-sound effect.

Drivers

A corresponding driver must be installed for the 2, 4 or 6-channel audio mode. If the drive is not installed yet, proceed as described in the chapter "Add-on modules / Upgrading", in the section "Drivers".

Connecting loudspeakers

The number of loudspeakers connected should match the number of audio channels you select in the driver software.

A26361-D2140-Z120-1-7419, edition 1

English - 9

Image 18
Contents Answers2 EnglishSie haben Page A26361-D2140-Z120-1-7419 Mainboard D2140 Technisches Handbuch Technical ManualAusgabe November November 2004 edition Page Übersicht/Overview Mainboard D2140 LEDContents Page Notational conventions Additional informationImportant notes Information about boardsList of features Onboard featuresSpecial onboard features Internal ports External portsSpecial features Brief instructions on installing mainboard Prior to installationInstallation Driver installationLAN port Interfaces and connectorsExternal ports LED 1 greenHard disk connection Internal ports and connectorsOr 6-channel audio mode via analogue audio channels Audio front panelAnalogue 2-channel audio output Using external audio connectionsSelecting settings for 2, 4 or 6-channel audio mode Analogue 4-channel audio outputPin assignment of internal ports Front panelUSB dual channel Floppy interface ATA interface Power supply BTX Additional power supply ATX12Skipping system and Bios Setup password pinpair a Settings with switches and jumpersSetting via control-panel plug connector Recovering System Bios pinpair BAdd-on modules / Upgrading Installing processor with heat sinkTechnical data Replacing the processorReplacing the processor Mounting heat sink Installing a memory module Upgrading main memoryAdding PCI cards Removing a memory modulePCI bus interrupts Selecting correct PCI slot Audio ModemMonofunctional expansions cards Replacing the lithium battery Bios update When should a Bios update be carried out?Bios update under Windows with DeskFlash utility Bios Recovery Recovering System Bios Microcode Update What is a microcode update?When should a microcode update be carried out? Drivers Error messages Bios update for installed CPU failedError messages Missing or invalid Nvram token System battery is dead Replace and run Setup Glossary