Dell 100-Mbps manual Drives in the Drive Cage, Inch Diskette Drive Removal

Page 54

Drives in the Drive Cage

retaining screw

bracket mounting screw (2)

hook (2)

bracket catch

Figure 4-9. 3.5-Inch Diskette Drive Removal

To remove a drive from the 3.5-inch diskette drive bay, follow these steps:

1.Disconnect the DC power cable and the interface cable from the back of the drive.

2.Remove the bracket retaining screw.

3.Release the bracket catch from the chassis.

Rotate the drive bracket to the right, and lift the bracket from the top of the drive bay.

4.Remove the two mounting screws from each side of the drive and remove the drive from the bracket.

To replace a 3.5-inch diskette drive, locate the two hooks on the right side of the bracket that hold the drive in position. Engage those two hooks in the side of the drive.

4-10 Dell OptiPlex GXpro Systems Service Manual

Image 54
Contents 659,&0$18$ Page Contents Chapter Basic Troubleshooting Chapter Beep Codes and Error MessagesChapter Removing and Replacing Parts Index FiguresTables 16. Expansion-Card Cage RemovalPage Read This First System Overview System Features System Unit Orientation Front-Panel Features Dual-Processor Capability Advanced Expansion SubsystemAudio Controller Hard-Disk Drive OptionsEnhanced Dual-Interface Eide Subsystem PCI Video CardDesktop Chassis Thermal MonitoringSystem Unit System Power SupplyPin Assignments for the DC Power Connectors Smart SupportDC Power Connector P1 DC Power Distribution DC Power Connector P7Power Distribution System Board Layout Video MemoryMain Memory System Board JumpersInterrupt Assignments Jumper DescriptionsDMA Channel Assignments IRQ14Technical Specifications Technical SpecificationsNIC CtrlAltEnter To 149 F Page Basic Troubleshooting Initial User ContactExternal Visual Inspection Observing the Boot Routine Internal Visual Inspection Running the Diskette-Based Diagnostics Eliminating Resource ConflictsGetting Help Beep Codes and Error Messages Post Beep CodesPost Beep Codes System Error Messages HaltedSystem Error Messages System could not suc System Setup program Incorrect configuration During memory test Faulty or improperly System does not recog Faulty diskette, diskette MS-DOS unable to Defective sectors on dis At system start-up One or both micro Removing and Replacing Parts Recommended ToolsPrecautionary Measures Protection of the EquipmentFloor Stand Pull the floor stand away from the system unitSystem Unit Cover System-Unit Cover RemovalEject, Power, and Reset Buttons Eject, Power, and Reset Button RemovalFront-Panel Inserts Front-Panel Insert RemovalIndicator Card Indicator Card RemovalSpeaker Speaker RemovalDrives Drive HardwareDrives in the Drive Cage 5-Inch Diskette Drive Removal10 .25-Inch Drive Removal Hard-Disk Drives Lift the hard-disk drive bracket out of the system unit12. Hard-Disk Drive Removal System Power Supply 13. Power Supply RemovalMicroprocessor Fan 14. Microprocessor Fan RemovalSystem Board Components 15. System Board ComponentsExpansion Cards Expansion-Card CageExpansion Card 17. Expansion-Card RemovalRiser Board 18. Riser Board RemovalDIMMs 19. Dimm RemovalMicroprocessor/Heat Sink Assembly 21. Microprocessor Securing Clip22. Microprocessor Removal Terminator or Add-In Card Terminator CardAdd-In Card 24. Add-In Card RemovalSystem Battery Remove the batterySystem Board Remove the system board as followsSystem Setup Program System Setup Screens USBTable A-1. System Setup Categories Be shadowed or cached. If video problems Check the monitor documentation to make Table A-1. System Setup Categories Index Dskt connector, 1-12,4-16dual-processing,1-5 ECC DIMMs LINE-IN connector, 1-12,4-16 USB description Location, 1-4,1-12