Dell 100-Mbps manual DIMMs, Dimm Removal

Page 64

DIMMs

DIMM

2.

securing clip (2)

1.

Figure 4-19. DIMM Removal

To remove a DIMM, push outward on the DIMM socket’s securing clips until the DIMM is released from its socket. Then lift the DIMM away from the socket.

DIMM

2.

securing clip (2)

1.

Figure 4-20. DIMM Installation

To replace a DIMM, press outward on the securing clips at each end of the socket until they snap open. Orient the DIMM to the socket, and press the DIMM straight down into the socket slot until the securing clips snap into place around the ends of the DIMM.

4-20 Dell OptiPlex GXpro Systems Service Manual

Image 64
Contents 659,&0$18$ Page Contents Chapter Beep Codes and Error Messages Chapter Basic TroubleshootingChapter Removing and Replacing Parts Index FiguresTables 16. Expansion-Card Cage RemovalPage Read This First System Overview System Features System Unit Orientation Front-Panel Features Dual-Processor Capability Advanced Expansion SubsystemHard-Disk Drive Options Enhanced Dual-Interface Eide SubsystemAudio Controller PCI Video CardDesktop Chassis Thermal MonitoringSystem Power Supply Pin Assignments for the DC Power ConnectorsSystem Unit Smart SupportDC Power Connector P1 DC Power Distribution DC Power Connector P7Power Distribution System Board Layout Video MemoryMain Memory System Board JumpersInterrupt Assignments Jumper DescriptionsDMA Channel Assignments IRQ14Technical Specifications Technical SpecificationsNIC CtrlAltEnter To 149 F Page Basic Troubleshooting Initial User ContactExternal Visual Inspection Observing the Boot Routine Internal Visual Inspection Running the Diskette-Based Diagnostics Eliminating Resource ConflictsGetting Help Beep Codes and Error Messages Post Beep CodesPost Beep Codes System Error Messages HaltedSystem Error Messages System could not suc System Setup program Incorrect configuration During memory test Faulty or improperly System does not recog Faulty diskette, diskette MS-DOS unable to Defective sectors on dis At system start-up One or both micro Removing and Replacing Parts Recommended ToolsPrecautionary Measures Protection of the EquipmentFloor Stand Pull the floor stand away from the system unitSystem Unit Cover System-Unit Cover RemovalEject, Power, and Reset Buttons Eject, Power, and Reset Button RemovalFront-Panel Inserts Front-Panel Insert RemovalIndicator Card Indicator Card RemovalSpeaker Speaker RemovalDrives Drive HardwareDrives in the Drive Cage 5-Inch Diskette Drive Removal10 .25-Inch Drive Removal Hard-Disk Drives Lift the hard-disk drive bracket out of the system unit12. Hard-Disk Drive Removal System Power Supply 13. Power Supply RemovalMicroprocessor Fan 14. Microprocessor Fan RemovalSystem Board Components 15. System Board ComponentsExpansion Cards Expansion-Card CageExpansion Card 17. Expansion-Card RemovalRiser Board 18. Riser Board RemovalDIMMs 19. Dimm RemovalMicroprocessor/Heat Sink Assembly 21. Microprocessor Securing Clip22. Microprocessor Removal Terminator or Add-In Card Terminator CardAdd-In Card 24. Add-In Card RemovalSystem Battery Remove the batterySystem Board Remove the system board as followsSystem Setup Program System Setup Screens USBTable A-1. System Setup Categories Be shadowed or cached. If video problems Check the monitor documentation to make Table A-1. System Setup Categories Index Dskt connector, 1-12,4-16dual-processing,1-5 ECC DIMMs LINE-IN connector, 1-12,4-16 USB description Location, 1-4,1-12