Parallel Menu
Use the Parallel menu to change printer settings on jobs sent through a parallel port.
From | You can: |
this |
|
menu: |
|
NPA | Send print jobs to the printer and query printer status information at the same time. |
Mode | Off |
| |
| On |
| Auto* |
Protocol | Receive information at a much higher transmission rate if your printer is set to Fastbytes (if your computer |
| supports Fastbytes), or receive information at a normal transmission rate if your printer is set to Standard. |
| Standard |
| Fastbytes* |
Parallel | Determine whether the parallel port data is sampled on the leading (on) or trailing (off) edge of the strobe. |
Mode 2 | Off |
| |
| On* |
MAC | Configure the printer to process Macintosh binary PostScript print jobs. |
Binary | |
PS | |
| |
| system. |
| NOTE: This setting can cause print jobs sent from Windows to fail. |
| |
| systems. |
* Factory default setting
Setup Menu
Use the Setup menu to configure how the printer formats the end of a line depending on the computer system being used.
From this | You can: |
menu: |
|
PPDS Emulation | Specify if you want to use the PPDS datastream. |
Deactivate*
Activate
NOTE: This menu is only displayed if a PPDS interpreter is available.
Auto CR after LF | Specify whether the printer automatically performs a carriage return (CR) after a line feed control |
| command. |
| Off* |
| On |
Auto LF after CR | Specify whether the printer automatically performs a line feed (LF) after a carriage return control |
| command. |
| Off* |
| On |