4bottom flex cable connector
5inverter connector
9.Remove the tape that secures the display panel connector and the tape that secures the middle of the
10.Pull the top
Replacing the 14.1-Inch Display Panel
1.Reconnect the top
2.Reconnect the bottom
3.Replace the tape that secures the display panel connector and the tape that secures the middle of the
4.Place the bottom edge of the display panel in the bottom of the top cover and elevate the top of the panel with your hand.
5.Lay the display panel in the top cover.
Reinstall the five M2 x
Display Latch
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
Removing the Display Latch
1.Remove the hard drive.
2.Remove the display assembly.
3.Remove the display bezel.
4.Remove the two M2.5 x
5.Lift the display latch and bracket up and out of the top cover.
1M1.7 x
2M2.5 x
3display latch
4bracket
Replacing the Display Latch
1.On
On
2.Replace the two M2.5 x