Page 32
1M2.5 x 12-mm screws (3)
2M2 x 3-mm screws (2)
3hard-drive bay door
5.Remove the two M2 x 3-mm screws that are located in the hard-drive bay door labeled "circle P."
6.Turn the computer over, and remove the three M2 x 3-mm screws that secure the palm rest to the bottom case:
a.Remove the two M2 x 3-mm screws that are located on the back edge of the bottom case, underneath the display assembly.
b.Remove the M2 x 3-mm screw located underneath the keyboard, on the right side of the bottom case, next to the microprocessor thermal cooling assembly.
7.Pull up on the pull-tab that is attached to the palm-rest flex cable connector to remove it from the interface connector on the system board.
1 | M2 x 3-mm screws (3) |
| |
2 | palm rest |
| |
3 | palm-rest flex cable |
| |
4 | bottom case |
5 | back center of the palm rest |
| |
6 | touch pad connector |
| |