Troubleshooting the Card Reader
CAUTION: Do not remove the device while reading or writing media. Doing so may cause loss of data or malfunction in the media.
Problem
Drive letter is not assigned. (Windows® XP only)
Drive letter is assigned, but the media is not accessible
The media has been ejected during writing or erasing.
Cause
Conflict with network drive letter.
The media needs reformatting.
Displays the error message, "Error copying file or folder."
Displays the error message, "Cannot write folder (folder name) or file (file name)," during writing, or, "Cannot remove folder (folder name) or file(file name),". While erasing, you cannot write or erase in the same folder or file name.
Solution
A.
B. In the list of drives in the right panel,
Letter and Paths.
C. Click Change, and in the
D. Click OK, ... then click OK again
Reinsert the media and write or erase again.
Format the media for writing or erasing the same folder or file name.
Despite the disappearance of the
Cannot format or write on the media.
Card reader is not working
Although the | Format the media for writing or erasing the same folder or file name. |
during writing, if you eject your media while |
|
the LED is still blinking, then you cannot |
|
complete your action on the media. |
|
|
|
|
|
Write protect switch is enabled. | Verify that the write- protect switch of the media is unlocked. |
|
|
|
|
USB interface is not working. | Check that your monitor is powered on. |
Reconnect the upstream cable from your computer to the monitor.
Reinsert the media.
Switch off and then turn on the monitor again.
Reboot the computer.
Back to Contents Page