Getting Started
1.4.2 Ribbon Loading Instructions
Load ribbon as shown below in Figure 1-7. The ribbon can be wound directly on to the hub and held with a clasp, or a used ribbon core can be placed on the hub. To load the ribbon complete the following steps:
1.Disengage the Printhead by rotating the Head-Lift Lever counterclockwise to the ‘up’ position.
2.Slide the Ribbon on to the Ribbon Supply Hub. Route the ribbon, (see Figure 1-7), and attach the ribbon to the Ribbon Take-up Hub.
3.Engage the Printhead by rotating the Head-Lift Lever clockwise to the ‘down’ position.
Figure 1-7 Ribbon Loading
