Datamax Allegro 2 Copy Module, Metric, Print Test Label, System Test Label, Edit Module Name

Creating Labels Using Internal Batch Software

Copy Module:	Copies graphic images and/or label
	formats from one memory module to
	another. Be certain that the Write Protect
	Switch is ‘on’ for the source module and
	‘off’ for the destination module.
Metric:	Each time the number 3 is pressed, the
	screen will toggle between Metric ‘No’
	and Metric ‘Yes’.
Print Test Label:	Prints a Printhead Test Label and is used
	as a relative gauge of Printhead condition
	and wear.
System Test Label:	Lists all current Printer settings and
	checks both ROM and RAM. Prints a
	Printhead Test Label after the system test.
Edit Module Name:	This will allow you to change the name of
	the module.
Reset Printer:	This is the same as the <SOH #>
	Command in the standard Printer Mode.
	If switch 7 is on than the Internal Batch
	will take over.
Exit To RS-232 System:	This is the same as turning Switch 7 ‘off’
	and resetting the Printer. You can use the
	<STX g> command to enter the Internal
	Batch without using switch 7 in the rear
	of the Printer.
Pack Module Data:	All the label formats are stored in a 256K
	Flash Module; therefore, only the entire
	Module can be cleared. For this reason,
	the data will occasionally need to be
	packed from time to time when the
	memory becomes low.

56 Allegro2