Cobra Electronics CPI M400 Quick Evaluation Before Installation, Be Sure to Have on Hand

Page 5

Quick Evaluation Before Installation

Introduction

Quick Evaluation Before Installation

Quick Evaluation Before Installation

Introduction

To Check Your Inverter’s Performance Before Installation:

This section provides you with basic information about the inverter and how to check its performance before installation.

Be Sure to Have on Hand:

Power Supply

A 12 volt DC power source (such as a vehicle battery).

 

The power source must provide between 11 and

 

15 volts DC and be able to supply enough current

 

to run the test load. As a rough guide, divide the

 

wattage of the test load by 10 to get the current

Cables

(in amperes) the power source must deliver.

 

 

The provided 2 foot cigarette lighter cable.

 

Only use the cable provided with your inverter. The

 

cigarette lighter cable is suitable for operating the

 

inverter at loads up to 150 watts. Connect by securely

 

inserting the plug into the cigarette lighter socket

CAUTION Do not use the cigarette lighter cable for loads higher than

150 watts. When connecting loads larger than 150 watts, please connect the inverter directly to the battery.

Test Load

A test load that can be plugged into the AC

 

receptacle on the inverter for short term

 

testing at a low power level.

On/Off Switch to Off

Connect Terminals

Connect Power Source

On/Off Switch to On

Connect Test Load

1.Turn the inverter Off (see page 13 for details). If the power source is a DC power supply, switch it Off as well.

2.Connect cables to Power Input Terminals (see page 8 for details).

3.Connect cable to Power Source (see page 8 for details).

4.Check to make sure all connections are secure.

5.Turn the inverter On. If the power source is a DC power supply, switch it On first.

6.Plug in the test load.

The inverter should supply power to the load. If the inverter is not working properly, refer to the Troubleshooting Guide on page 17 or Power and Protection Indicators section on page 15.

7. Test the GFCI Outlet (see page 14 for details).

4 English

Test GFCI Outlet

Nothing comes close to a Cobra® 5

Image 5
Contents Customer Assistance Operators English and Spanish How Your CobraMarine Power Inverter WorksOur Thanks To You Table of Contents Controls/Indicators and Product FeaturesImportant Safety Information Important Safety InformationCobraMarine M400 Output Waveform Ground Fault Circuit Interrupter Gfci OutletQuick Evaluation Before Installation Quick Evaluation Before InstallationTo Check Your Inverter’s Performance Before Installation Be Sure to Have on HandMounting Installation RequirementsTo Connect the Cables Between the Inverter and the Battery Connecting CablesConnecting Cables Power Consumption Power ConsumptionTo Determine the Battery Ampere-Hour Capacity You Require Power x Operating Time = Watt-HoursPower On or Off Ground WiringGfci Outlet Power and Protection IndicatorsOperating Limits Power Output Operating Limits Troubleshooting GuideTroubleshooting Guide Problem/Symptom Possible Causes Input VoltageWarranty SpecificationsSpecifications Limited 1-Year Warranty For Products Purchased In the U.S.AMaintenance Maintenance and Product ServiceProduct Service Amount Shipping/Handling Accessories and Order Form
Related manuals
Manual 14 pages 15.97 Kb