Ground Wiring
Installation
Ground Wiring
•
There is a screw on the rear panel for Chassis Ground. This is to connect the chassis of the inverter to ground.
The Chassis Ground Screw must be connected to a grounding point, which will vary depending on where the unit is installed. Use a #8 AWG copper wire (preferably with green/yellow insulation) to connect the chassis ground screw to the grounding point.
Chassis Ground
In a Vehicle:
Connect the Chassis Ground to the chassis of the vehicle.
In a Boat:
Connect to the Boat Grounding System.
In a Fixed Location:
Connect the Chassis Ground Screw to earth ground by connecting to a ground rod (a metal rod pounded into the earth) or other proper service entrance ground.
12 English
Power On or Off
Operation
Turning Your Inverter On or Off
•
Be sure to have your power inverter properly installed before attempting to turn the unit On (see “Installation” page 6).
To Turn the Power Inverter On:
1.If a DC power supply is being used as the power source, switch it On.
2.On the left side panel, switch the On/Off Switch to On.
On/Off Switch to On
The inverter is now ready to deliver AC power to your loads. If several loads are to be operated by the inverter, turn them On separately, after the inverter has been turned On. This will ensure that the inverter does not have to deliver the starting currents required for all the loads at once.
To Turn the Power Inverter Off:
1. On the left side panel, switch the On/Off Switch to Off.
On/Off Switch to Off
NOTE The On/Off Switch turns the control circuit in the inverter On and Off. It does not disconnect power from the inverter.
When the switch is in the Off position, the inverter draws no current from battery. When it’s in the On position, but no power is being supplied to the load, the inverter draws less than 500 milliamperes from the battery. This is low current draw. It would take more than a week to discharge a 100
Nothing comes close to a Cobra® 13