Citizen Systems iDP-3540, 3541 user manual Input Buffer Back-up Function

Page 18

iDP-3540/41 User’s Manual

6-6. Self Test Printing

Your printer has a built in self print function for purpose of checking print operation without the need for any other external device.

Procedures for Actuating the Print Function

1)Be sure that a paper roll is properly loaded.

2)Confirm that the ribbon cassette is properly installed and turn the power switch off.

3)Turn the power switch ON while pressing the LF switch, and release the LF switch after the self test operation has begun.

In the above operation, the self print function will stop automatically when completed. However, the self print function will not operate without paper.

6-7. Alarm and Paper Near-End Detection

This printer has the paper near-end sensor to stop the operation when the paper comes to near-end, sending out both BUSY and FAULT signals. This status is indicated by the SEL / ALARM lamp blinking at an interval of 1.0 second.

7. Input Buffer Back-up Function

7-1. Input Buffer Back-up

If the power is turned off, or there is a power failure during printing, the data in the input buffer will be retained. When the power comes back on, the power failure symbol (…..PD) will be printed,

and then the data which was interrupted will be printed from the beginning of the line where the interruption occurred.

Note: The input buffer back-up function may not operate properly if the related capacitor is not sufficiently charged. This may be the case if the printer has not been operated for a long period of time. After the printer power switch has been turned on for 10 minutes, the buffer back-up should be effective for approximately 24 hours or more.

7-2. Clearing the Input Buffer

In case it is desired to delete the data in the input buffer, the power switch should be turned on while pressing the SEL switch. When deletion of the buffer is completed the buzzer will sound. Please be sure to continue pressing the SEL switch until that time.

If the printer fails to work properly at the time the power switch is turned on, please delete the input buffer as described above before inputting new data.

CITIZEN

18/48

Image 18
Contents User’s Manual LVD EMCImportant Safety Instructions Contents Slide Switch Setting Serial interface specifications only Introduction Basic Specifications Specifications Citizen Block Diagram External Appearance and parts Description 12/48 13/48 Preparation IDP-3540/41 User’s Manual Ribbon Cassette Installation 16/48 17/48 Input Buffer Back-up Function Input Buffer Back-upParallel Interface Fault DataACK 21/48 22/48 Serial Interface TTL DTR25/48 26/48 27/48 8V Busy TD Mark = -8V +8V Ready Space = +8V Current on Ready External Output Function Selection IDP-3540/41 User’s Manual RS-422A type only Function Print Control Functions FF0CH SO0EHSI0FH LF0AH CR0DHRS1EH 37/48 38/48 39/48 40/48 DEFAULT=20 42/48 Initial Setting Maintenance General CautionsCharacter Code Tables IDP-3540/41 User’s Manual Individual Country Character Codes External Dimensions IDP-3540/41 User’s Manual Model iDP3541