1st byte
D8 |
|
|
|
|
|
| D1 | |
0 | 0 | 0 | 0 | 0 | 0 | 0 | 0 |
|
|
|
|
|
|
|
|
|
|
FF(0C)H
2nd byte
D8 |
|
|
|
|
|
| D1 | |
0 | N7 | N6 | N5 | N4 | N3 | N2 | N1 |
|
|
|
|
|
|
|
|
|
|
n(N7 N1) (Binary digits)
When the number of lines to be fed (2nd byte) is
(1st byte), the paper will be fed by the number of lines specified. The number of lines to be fed can be specified from n = 1 to 127. If “0” is specified, paper feed will not be carried out.
When there is data in the print buffer at the time this command is applied, this data will first to printed out and then line feeding of “n” – lines will be performed.
D8 |
|
|
|
|
|
| D1 | |
0 | 0 | 0 | 0 | 1 | 1 | 1 | 0 |
|
|
|
|
|
|
|
|
|
|
SO(0E)H
The data following this command, are printed out in twice the normal width.
This mode will continue until the corresponding cancel command is input, or automatically released after printing one line. Since enlarged characters are twice the normal width, care should be taken to avoid exceeding the column capacity.
This command is used for canceling the enlarged character mode set by SO, and the following data will be printed out in the normal character mode.
D8 |
|
|
|
|
|
| D1 | |
0 | 0 | 0 | 0 | 1 | 1 | 1 | 1 |
|
|
|
|
|
|
|
|
|
|
SI(0F)H
CITIZEN | 34/48 |