Citizen Systems iDP-562 user manual FCC Warning

Page 4

iDP-562 User’s Manual

*iDP562-RSL/RS, iDP562-CNL/CN type

IMPORTANT:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Shield cable must be used.

*iDP-562-RSL2 type only NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment of and so on, the user is encouraged to try to correct the interference by one or more of the following measures.

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receive is connected.

-Consult the dealer or an experienced radio/TV technician for help

Shield cable must be used.

*iDP562-RSL/RS, iDP562-RSL2, iDP562-CNL/CN type.

FCC WARNING

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

*iDP562-RSL/RS, iDP562-CNL/CN type

"This digital apparatus does not exceed the Class A for radio noise emissions from digits apparatus set out in the Radio Interference Regulation of the Canadian Department of Communications."

*iDP562-RSL2 type only

"This digital apparatus does not exceed the Class B for radio noise emissions from digits apparatus set out in the Radio Interference Regulation of the Canadian Department of Communications."

CITIZEN

4

Image 4
Contents User’s Manual EMC LVDCITIZEN2 Important Safety Instructions CitizenFCC Warning IDP-562 User’s Manual Contents Outline Basic Specifications Appearance and Parts Name Citizen Operation Citizen Citizen Serial Interface Current LoopSpace = TTLOFF Data + CR OFFOFF Data + LF Data + CR + LF OFF Data + LF + CRFault Current TTLLoop GNDCitizen Citizen 6CURRENT Loop Data BIT + Parity BIT Start BITStop BIT Citizen Citizen Parallel Interface Data 3 Data 4 Data 5 Data 6 Data 7 DataForeign character DSW-4 ACK, BUSY, SLCT, STB, Fault STB Twisted Pair GND Data ACK Busy Slct FaultPIN no LOW level Citizen Control Code CR0D ESC1B ESC81B Initial Setting Character Code Table Citizen SO Side Maintenance