Citizen Systems 500 user manual Interface Setup Mode Parallel and Serial

Page 24

English

*1 Depending on the Emulation, different characters sets are available:

EPSON emulation: Italic, Graphic 1 or Graphic 2

IBM emulation: Graphic 1 or Graphic 2

OKI emulation: Standard, Line G or Block G

*2 If the current Country or Code Page setting is not a setting available from the control panel but throught software selection then both PITCH indicators will blink.

Interface Setup Mode (Parallel and Serial)

With the printer switched ON, load a sheet of paper. Then turn the printer off.

While pressing the PITCH button, turn the power on to enter the Initial Setup mode. When you release the PITCH button, the current printer settings will be printed automatically.

The QUIET indicator, POWER indicator, ON LINE indicator and FONT indicators will be blinking.

Press and release the FONT button to select the item. Each time you press FONT, you will advance to the next item.

1.Select the desired item according to the status of the FONT indicators (on, off, blinking) by referring to the following table or to the printout produced by the printer.

2.Press and release the PITCH button to set the item’s status. The item’s status will change each time you press the PITCH button. The status of the item is shown by the pitch indicators will be either on, off or blinking. By referring to the following table or to the printout produced by the printer the status can be selected.

To change additional settings, repeat steps 1 and 2 above for each item required.

Press LOAD/PARK to exit the Initial Setup mode. The FONT indicators will go off and the current conditions will print.

24

Image 24
Contents User’s Manual Contents Maintenance and Troubleshooting SpecificationsProduct Warranty OKIUser Safety Instructions Introduction About This Printer ManualWhat to do if you have problems For the latest informationInstallation and setup for first use Unpacking Installing the Platen KnobParts of the Printer Front ViewRear View Bottom ViewConnecting to a Computer Installing Ribbon Cassette Paper Head Gap Adjustment Rear Tractor ModeFriction Feed Mode Bottom Tractor ModeFanfold Paper Rear Tractor Mode Paper Feed Selection Paper SourceFanfold Paper Bottom Tractor Mode English Single Sheets and Envelopes Friction Mode Tearing Off Paper Control Panel Keys Selecting a Character FontHigh Speed Draft Mode Selecting a Character PitchQuiet Mode Line Feed / Form Feed LF/FFTop Of Form Micro Line Feed and Reverse Micro Line FeedSaving Top Of Form Paper Parking LOAD/PARKInitial Setup Mode Entering Initial Setup ModeFactory Initialisation English Interface Setup Mode Parallel and Serial Microsoft Windows IBM PCs Or CompatiblesChoosing a Suitable Emulation Windows 95 Driver Installation Windows 98 Driver InstallationManually Installing a Windows 95 or 98 Driver Windows NT4 Driver Installation Window NT4 Single User Windows NT4 in the Network EnvironmentMaintenance and Troubleshooting Printer Self Test Periodic MaintenanceTroubleshooting Guide Printer does not power up Power is on but printer does not printCarriage stops moving, all indicators start blinking Paper wrinkles when using tractor feedSpecifications Printer Specifications Paper Specifications Fanfold PaperContinuous Labels Single SheetPrinting Area Fanfold Paper and Continuous LabelsSingle Sheet and Envelopes