AOC i2353 manual Hotkeys, Power, Volume, Auto/Source/Exit

Contents Page Installation SafetyPower CleaningService Warranty Statement for EuropeWarranty Statement for North & South America excluding Brazil Safety National ConventionsPower Installation Cleaning Other Power Cable Analog Cable HDMI Cable SetupContents in Box AdaptorSetup Stand & Base Adjusting Viewing Angle Connecting the Monitor 1 2 3 4Wall Mounting Windows Vista AdjustingSetting Optimal Resolution 1 Click START5 Click Display Settings 6 Set the resolution SLIDE-BAR to 1920 byFor Windows XP Windows XP2 Click SETTINGS 3 Click CONTROL PANEL 4 Click Appearance and Themes 5 Double click DISPLAYWindows ME/2000 7 Set the resolution SLIDE-BAR to 1920 by4 Double click DISPLAY Volume HotkeysPower Auto/Source/ExitClear Vision OSD Setting Basic and simple instruction on the control keysPress or to select Luminance, and press to enter LuminancePress Menu to display menu Press or to select submenu, and press to enterAdjust to Gamma1 Press or to adjustBacklight Adjustment Adjust to GammaImage Setup Press or to select Image Setup, and press to enterAdjust Picture Phase to reduce Horizontal-Line noise Adjust picture Clock to reduce Vertical-Line noisePhase Adjust picture sharpnessColor Setup Press or to select Color Setup, and press to enterDisable or Enable Nature Skin Mode Color setupDisable or Enable Full Enhance Mode Disable or Enable Green Field ModePicture Boost Press or to select Picture Boost, and press to enterAdjust Frame Contrast Adjust Frame SizeAdjust Frame Brightness Adjust Frame horizontal PositionOSD Setup Press or to select OSD Setup, and press to enterTimeout Adjust the horizontal position ofAdjust the vertical position of OSD Adjust the OSD TimeoutExtra Press or to select Extra, and press to enterHDMI 1/HDMI LED Indicator ExitWindows DriverMonitor Driver 1.Start Windows4.Ckick on the “Change display settings” button 5.Click the “Advanced Settings” button6.Click the “Monitor” tab and then click the “Properties” button 7.Click the “Driver” tab 9. Select Let me pick from a list of device drivers on my computer13. Close all open windows and remove the CD 2. Click Personalization and then Display Settings 3. Click Advanced Settings5. Click Update Driver... in the Driver tab 8. Select your monitor model and click on the Next button3. Select and click on the category ‘Appearance and Themes’ 1. Start Windows XP2. Click on the Start button and then click on Control Panel 4. Click on the Display Item6. Select Monitor tab 5. Select the Settings tab then click on the Advanced button7. Click on the Driver tab and then click on Update Driver... button If the Properties button is active, click on Properties button11. Click on the Open button, then click the OK button 12. Select your monitor model and click on the Next button13. Click on the Finish button then the Close button Windows ME i-Menu e-Saver Screen+ Power LED Is Not ON TroubleshootProblem & Question Ghosting Shadowing ProblemMonitor Is Stuck In Active Specification General SpecificationSTAND Preset Display ModesRESOLUTION HORIZONTALPin Assignments Signal NamePin No Plug and Play Plug & Play DDC2B FeatureRegulation FCC NoticeWEEE Declaration Service Warranty Statement for EuropeInformation in this document is subject to change without notice Warranty Statement for North & South America excluding Brazil CHILE http//cl.aoc.com/support/findservicecenter USA http//us.aoc.com/support/findservicecenterARGENTINA http//ar.aoc.com/support/findservicecenter COLOMBIA http//co.aoc.com/support/findservicecenter