Denso BHT-103, BHT-7500 manual Starting a Telnet Session

Quick Start

Starting a Telnet Session

Press <1> Execute Program.

SYSTEM MENU

1:EXECUTE PROGRAM

2:DOWNLOAD

3:UPLOAD

4:SET SYSTEM

5:TEST

6:VERSION

7:FTP

8:RF

Select an emulation and press Enter.

After a Telnet session has been successfully established, the terminal will remain in session for a maximum of 30 minutes at a time until it has been authorized. Once authorized, there is no software restriction on the session time. The instructions for authorizing the terminal are presented in Authorizing PowerNet.

Note: In order to run Twin Client, the heap area must be set up as follows. (This is valid for the BHT7500 only.)

Start system menu ([SF]?[1]+[PW])

Select set system menu ([4]?[ENT])

Select heap size set menu ([SF]+[1])

+	--------------------------		+
SET FOR RUNNING C PROGRAMS
1:HEAP SIZE [			76]KB
	(in 4KB units)
	MIN :	76KB
	MAX :	140KB

Set heap size as 140KB ?push [ENT] (cursor move to ]) ?push [C] (70 is turn off) ?push [1]?[4]?[0]?[ENT] ?push[C] to system menu

Supported Equipment Manual • March, 2006 2-17