Denso BHT-103 manual Edit License Key, Run Site Survey, Switch Client Modes, Run Client Emulator

Standard Setup

Host 0

IP 206.183.67.155

Port 23__

<F3> Save <F7> Quit

Press F3 to save the configurations.

Edit License Key

The client software can be authorized automatically, as described in the next section, Authorizing PowerNet. This menu option permits authorization of each terminal manually. Select this option to obtain the terminal's Identification Code, which is used to obtain the Authorization code from the Connect web site, as described in the next section.

The 12-digits displayed at the terminal screen top is the terminal’s Identification Code.

00A0F826E614 Authorization

______________

not authorized

<F3> Save <F7> Quit

Type the authorization code into the field as it appears on the web site. Punctuation characters, such as the hyphen (-), are required. Press F3 to save the authorization code.

Run Site Survey

This option (a feature of Spectrum 1) is applicable to Release 5.0 and may be obsolete for your terminal.

Switch Client Modes

The PowerNet Twin Client normally operates in Telnet mode, which provides direct connection to Telnet hosts. It can also operate in Server mode, through a PowerNet OpenAir server. Select this menu option to switch between Server and Telnet modes of operation. Note that the host socket address for the PowerNet OpenAir servers is 1800, which must also be changed in the Edit Server/Host IPs menu described above.

Run Client Emulator

After all desired changes have been made, select this option to return to the Twin Client main menu. Then press any key to establish the Telnet session and begin emulation. Refer to the Quick Start 3 sub-section, Starting a Telnet Session, for further instructions.

Setting Default Executable

From the System Menu, press <4> Set System and press <1> Execute Program.

Supported Equipment Manual • March, 2006 2-25