Graco 15V534 Connect the Cable to the RoboMix Control Board, RoboMix Control Board J1 Connections

Installation

Connect the Cable to the RoboMix Control Board

NOTICE

To avoid damaging circuit board when servicing, wear grounding strap on wrist and ground appropriately.

1.See the ProMix 2KS Repair-Parts manual. Open the RoboMix to access the control board.

2.Connect the 10 position connector (24) to J1 on the control board. See FIG. 9.

J1 Pins 1-4, 7-10

(10 position

Connector 24)

FIG. 9: RoboMix Control Board J1 Connections

3.Connect the 6 position connector (25) to J8 on the control board. See FIG. 10

J8 Pins 1-4

(6 position Connector 25)

FIG. 10: RoboMix Control Board J8 Connections

8 313212A