Connect a Booth Control to the RoboMix (to operate as a manual system)
Connect a Booth Control to the RoboMix (to operate as a manual system)
To use the RoboMix as a manual system, order the 15V350 Booth Control Kit and connect as follows. The kit includes a booth control module, wall bracket, and 50 ft (15.25 m) cable.
NOTICE
To avoid damaging circuit board when servicing, wear grounding strap on wrist and ground appropriately.
Cable Path
TI12511a
Booth Control
1.See FIG. 13. Mount the booth control in a convenient location near the RoboMix. Bring the cable to the RoboMix and thread it through the cable path at the back.
2.See the ProMix 2KS
3.Connect the cable to J7 on the control board. Close up the RoboMix and return to operation.
J7. Plug In for
Booth Control
Cable
Booth Control Cable
RoboMix Control Board
RoboMix
TI15110a
FIG. 13. Connect a Booth Control to the RoboMix
12 | 313212A |