Hand Held Products manual Calibrating the QC890 Verifier

Page 20

4.For the Windows Mobile for Pocket PC version, select Device and then Scan from the Scan Data tab.

Calibrating the QC890 Verifier

Note: Calibration is a requirement of the ISO/IEC standards and must be performed with each aperture change.

When calibrating the QC890 Verifier system, the QC890 Verifier must be connected to QCID. While preparing to calibrate the QC890 Verifier system, it is important to align the center of the reflectance page symbol to the center arrows and to keep the QC890 Verifier flat and level to the surface of the reflectance page.

The reflectance page is a precision standard that is made of photographic materials. To ensure proper calibration, you must replace the reflectance page if it becomes dirty or physically damaged. Make sure to use only the original calibration tools that were supplied with your QC890 Verifier kit or certified replacements obtained from Hand Held Products.

1.Place the verifier on top of the symbol.

2.Press the scan button on top of the unit to turn on illumination.

3.Look through the unit’s window to align the unit with the bar code.

Note: The best verification data is gathered by aligning the center of the symbol to the center arrows.

4.Press the scan button on top of the unit a second time while the illumination is on to scan the calibration bar code. You will hear a series of beeps and

3 - 2

Quick Check® 890 User’s Guide

Image 20
Contents User’s Guide Disclaimer Table of Contents Maintenance QC890 Verifier Features Getting StartedIntroduction Unpacking the QC890 VerifierScan Button LEDs Using the QC890 VerifierScan Button Special Features Physical ConnectionsUser LED Indications Audio SoundSpecifications Internal BatteryCharging the Battery Powering On the QC890 VerifierInstallation of Quick Check ImageData Quick Check ImageDataQuick Check ImageData Communication InterfacesUSB COM Port Emulation RS-232 Selections BluetoothRS-232 Serial Communication Interface Using the QC890 Verifier with Bluetooth Devices Enabling Your Device for Bluetooth Quick Check 890 User’s Guide Enabling Qcid for Bluetooth Using Quick Check ImageData Help System Quick Check 890 User’s Guide Scanning a Bar Code Symbol Using the QC890 Verifier Scanning a Bar Code Symbol Using Quick Check ImageDataCalibrating the QC890 Verifier Scanning Properly Using a Pen/Mouse Wand Calibrating an External Pen/Mouse Wand Scanning Properly Using the QC3800V Linear Imager Calibration Log Reflectometer Mode Quick Check 890 User’s Guide Maintenance Cleaning the External DevicesQC890 Verifier RecertificationQuick Check 890 User’s Guide Product Service and Repair Customer SupportOnline Product Service and Repair Assistance Technical AssistanceLimited Warranty Online Technical AssistanceQuick Check 890 User’s Guide Apertures Pen/Mouse Wand Aperture SelectionQuick Check 890 User’s Guide Menu Setting Bar Codes Resetting the Standard Product DefaultsIllumination Timer Power Down TimerQuick Check 890 User’s Guide Symbology Defaults Operation Code Regular 2 Telepen UPC/EAN Iata 2 UnrecognizedQuick Check 890 User’s Guide Page Hand Held Products, Inc