Hand Held Products manual Using the QC890 Verifier, Scan Button LEDs

Page 6

The verifier tests the following symbologies:

Codabar

Interleaved 2 of 5

Code 11

MSI

Code 16K

PDF417

Code 39

Reduced Space Symbology (RSS-14,

 

RSS Limited, RSS Expanded)

Code 49

Regular 2 of 5

Code 93

Telepen

Code 128

UPC/EAN

IATA 2 of 5

 

Using the QC890 Verifier

The QC890 Verifier offers a choice of Automatic, 5, 6, and 10 mil aperture settings. External devices (i.e., mouse wands, pen wands, and linear imagers) are available with apertures designed to match the most common X dimensions. Wands are available with apertures of 3 (Mouse Wand only), 5, 6, 10, and 20 (Mouse Wand only) mil. These aperture sizes correspond to those specified in ISO/IEC 15416 Bar Code Print Quality Test Specification - Linear Symbols. The proper aperture should be selected based on the X dimension range shown in the table in the Pen/Mouse Wand Aperture Selection (page A-1) section.

Choosing an inappropriate scanning aperture results in inaccurate quality measures. Too small an aperture may detect reflectance non-uniformities (spots and voids) that would not affect scanning with a "normal" aperture size. Too large an aperture will not be able to resolve individual elements of the symbol.

Scan Button

The scan button on top of the unit wakes the unit from power down. A first press of the button turns on illumination and a second press activates reading capabilities.

Scan Button LEDs

•Red LED - error conditions

•Green LED - good symbols and configuration changes

1 - 2

Quick Check® 890 User’s Guide

Page 5 Page 7
Image 6
Page 5 Page 7
Contents User’s Guide Disclaimer Table of Contents Maintenance Introduction QC890 Verifier FeaturesGetting Started Unpacking the QC890 VerifierUsing the QC890 Verifier Scan ButtonScan Button LEDs User LED Indications Special FeaturesPhysical Connections Audio SoundCharging the Battery SpecificationsInternal Battery Powering On the QC890 VerifierQuick Check ImageData Installation of Quick Check ImageDataQuick Check ImageData Communication InterfacesUSB COM Port Emulation Bluetooth RS-232 Serial Communication InterfaceRS-232 Selections Using the QC890 Verifier with Bluetooth Devices Enabling Your Device for Bluetooth Quick Check 890 User’s Guide Enabling Qcid for Bluetooth Using Quick Check ImageData Help System Quick Check 890 User’s Guide Scanning a Bar Code Symbol Using the QC890 Verifier Scanning a Bar Code Symbol Using Quick Check ImageDataCalibrating the QC890 Verifier Scanning Properly Using a Pen/Mouse Wand Calibrating an External Pen/Mouse Wand Scanning Properly Using the QC3800V Linear Imager Calibration Log Reflectometer Mode Quick Check 890 User’s Guide QC890 Verifier MaintenanceCleaning the External Devices RecertificationQuick Check 890 User’s Guide Product Service and Repair Customer SupportOnline Product Service and Repair Assistance Technical AssistanceLimited Warranty Online Technical AssistanceQuick Check 890 User’s Guide Apertures Pen/Mouse Wand Aperture SelectionQuick Check 890 User’s Guide Illumination Timer Menu Setting Bar CodesResetting the Standard Product Defaults Power Down TimerQuick Check 890 User’s Guide Symbology Defaults Operation Code Regular 2 Telepen UPC/EAN Iata 2 UnrecognizedQuick Check 890 User’s Guide Page Hand Held Products, Inc
Top Page Image Contents