Hand Held Products 890 manual Scanning Properly Using the QC3800V Linear Imager

Page 23

3.After you type in your name and location, click OK. The following message appears:

Note: When using the external QC3800V linear imager, it does not report ISO/ IEC reflectance parameters; therefore no calibration is necessary or possible.

Scanning Properly Using the QC3800V Linear Imager:

1.The best reading position for the QC3800V linear imager is 6 inches (150mm) from the surface of the bar code to the face of the scanner, with an angle of incidence of 15 degrees from perpendicular. At this orientation, the system performance approximates an average circular aperture size of .006 to .008 inches (.152 to .203 mm). Extreme variations from this orientation may negatively affect the accuracy of some parameter results.

2.Scanning is initiated by depressing the trigger on the linear imager.

3.Listen for an audible tone. When the unit scans and decodes a bar code, it emits a single beep.

If the unit cannot decode a bar code after a trigger pull, nothing happens.

After a successful decode, with a result that passes the minimum acceptable grade, the unit emits another beep of the same tone.

A decode that fails to receive a grade above the minimum requirement causes the unit to emit a beep of a different tone.

Quick Check® 890 User’s Guide

3 - 5

Image 23
Contents User’s Guide Disclaimer Table of Contents Maintenance Unpacking the QC890 Verifier QC890 Verifier FeaturesGetting Started IntroductionScan Button LEDs Using the QC890 VerifierScan Button Audio Sound Special FeaturesPhysical Connections User LED IndicationsPowering On the QC890 Verifier SpecificationsInternal Battery Charging the BatteryCommunication Interfaces Installation of Quick Check ImageDataQuick Check ImageData Quick Check ImageDataUSB COM Port Emulation RS-232 Selections BluetoothRS-232 Serial Communication Interface Using the QC890 Verifier with Bluetooth Devices Enabling Your Device for Bluetooth Quick Check 890 User’s Guide Enabling Qcid for Bluetooth Using Quick Check ImageData Help System Quick Check 890 User’s Guide Scanning a Bar Code Symbol Using Quick Check ImageData Scanning a Bar Code Symbol Using the QC890 VerifierCalibrating the QC890 Verifier Scanning Properly Using a Pen/Mouse Wand Calibrating an External Pen/Mouse Wand Scanning Properly Using the QC3800V Linear Imager Calibration Log Reflectometer Mode Quick Check 890 User’s Guide Recertification MaintenanceCleaning the External Devices QC890 VerifierQuick Check 890 User’s Guide Customer Support Product Service and RepairTechnical Assistance Online Product Service and Repair AssistanceOnline Technical Assistance Limited WarrantyQuick Check 890 User’s Guide Pen/Mouse Wand Aperture Selection AperturesQuick Check 890 User’s Guide Power Down Timer Menu Setting Bar CodesResetting the Standard Product Defaults Illumination TimerQuick Check 890 User’s Guide Code Regular 2 Telepen UPC/EAN Iata 2 Unrecognized Symbology Defaults OperationQuick Check 890 User’s Guide Page Hand Held Products, Inc