Napco Security Technologies GEM-DXRP2 manual Glossary

Page 33

GLOSSARY

INTERIOR Button - Bypasses Interior Zones on arming (see Zones - Interior Zones).

Instant Protection - Arming without entry delay using the Fbutton while remaining on the premises.

Keypad - Puts control-panel functions at your fingertips. It can be mounted anywhere in your premises.

Manager's Mode - In a partitioned system, a low-security operating mode that allows arming by area.

Opening Window - (Optional). A time interval within which opening (disarming) is permitted without re- porting to the central station.

Overview Mode - In a partitioned system, a high-security mode of op- eration allowing area arming wherein the status of Areas 1 and 2 is simul- taneously displayed at the keypad.

Panic Buttons - Blue buttons on

the keypad (Gand 7,

8or 9). If enabled, pressing Gtogether with 7,

8or 9will alert the central

station of a fire, auxiliary, or police emergency.

Partitioned System - A system that has been subdivided into two or more (up to eight) independent subsystems (areas).

Pre-Alarm Warning. - A keypad sounder alert of an impending alarm. This option is programmable by zone for the same duration as that programmed for Abort Delay (see Abort Delay).

Report - A transmission to a central station notifying of a change in the status of the system (alarm, trouble, low battery, etc.).

Ringback - A beep after arming

verifying the central-station's receipt

of a closing report.

Service Code - A code intended for temporary use.

Sounder - A local warning device at each keypad to alert that (a) entry delay has started; (b) an attempt was made to arm with a zone in trouble;

(c)a Day-Zone condition exists (see Zones: Day Zone); (d) 10 seconds exit time remaining; (e) invalid code entered; or (f) central station acknowledged arming (see Ringback).

System Trouble - A problem (low battery, power failure, etc.) detected in the system.

Trouble - A zone fault; an open

door, window, or other problem that may prevent arming.

User Code - Your personalized code for arming and disarming the system. It may contain up to six digits.

33

Image 33
Contents AC on Ready Operating Guide for yourIntroduction Important Test Your System WeeklyTest your sounding device Test your telephone line Table of Contents Keypad Controls & Indicators Reset InstantON/OFF Setting the Alarm Arming When Leaving Cant ArmSilCANT/ ArmRst EXX-XX TrblREADY1 CANT/ARMBypassing Interior Zones Protecting Yourself While on the PremisesINT1+2 ArmedArmed Instant Protection Turning OFF the AL ARM Disarming When Returning DisarmXxxsec Hour Zone 24-Hour Zones programmed? ‰YES ‰NO Day Zone Day Zones programmed? ‰YES ‰NOFire Protection Fire ZonexxTRBL/ E41-XX Preparing a Fire Escape Plan Would You Like More Safety Information?Family Rehearsal Important! Read CarefullyFloorplan FloorplanLimitations of Fire Alarm Warning System Keypad Functions R Z R n O n / C h i me Y e s / N o L a y/ Ar m 1 4/ / N o On Zone 1 has not been received Central Station Monitoring Communicator FeaturesAdvanced Features ZONE02Bypass Page Programming Optional IntroductionProgramming User Codes User Programming Example Select the Program Mode as followsWait Keypad MessagesExitxx ARMED1Cancel ArmZnfArmSnd DAY ZN AlarmFire WrongAcfail SystblLobatt CommflClosing Window Optional. a GlossaryGlossary Glossary System Trouble Error Codes Following Statement is Required by the FCC Napco Limited Warranty