Napco Security Technologies GEM-DXRP2 manual Fire Protection, Fire Zonexx, TRBL/ E41-XX

Page 13

FIRE PROTECTION

(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)

r e s e t F I R E A L A R M A C O N

FIRE/

ZONEXX

Fire-Zone Alarm

If a fire is detected, “reset FIRE ALARM” will be displayed and the keypad sounder will pulse.

1.If a fire is in progress, evacuate the premises immediately! If necessary, call the Fire Department from an outside phone.

2.Press the Cbutton to silence the keypad sounder.

3.If there is no evidence of a fire, enter your User Code and press J to turn off the alarm.

4.Check smoke detector(s). If a smoke detector tripped, its red alarm indicator light will be on.

T R O U B L E A C O N

TRBL/ E41-XX

After the alarm condition is corrected (thermostat cooled down; smoke cleared from detector; etc.), pressing Cagain will reset the keypad within about 10 seconds.

Fire-Zone Trouble

1.If a problem in the fire-circuit is detected, “TROUBLE” (fire trouble) will display and the sounder will pulse to signal a malfunction.

2.Press Cto silence the sounder. Call for service immediately!

13

Image 13
Contents AC on Ready Operating Guide for yourImportant Test Your System Weekly IntroductionTest your sounding device Test your telephone line Table of Contents Keypad Controls & Indicators Instant ResetON/OFF Setting the Alarm Arming When Leaving ArmSil CantCANT/ ArmRst EXX-XX TrblREADY1 CANT/ARMBypassing Interior Zones Protecting Yourself While on the PremisesINT1+2 ArmedArmed Instant Protection Disarm Turning OFF the AL ARM Disarming When ReturningXxxsec Hour Zone 24-Hour Zones programmed? ‰YES ‰NO Day Zone Day Zones programmed? ‰YES ‰NOFire Zonexx Fire ProtectionTRBL/ E41-XX Preparing a Fire Escape Plan Would You Like More Safety Information?Family Rehearsal Important! Read CarefullyFloorplan FloorplanLimitations of Fire Alarm Warning System Keypad Functions R Z R n O n / C h i me Y e s / N o L a y/ Ar m 1 4/ / N o On Zone 1 has not been received Central Station Monitoring Communicator FeaturesZONE02 Advanced FeaturesBypass Page Introduction Programming OptionalProgramming User Codes User Programming Example Select the Program Mode as followsWait Keypad MessagesExitxx ARMED1ArmZnf CancelArmSnd DAY ZN AlarmFire WrongAcfail SystblLobatt CommflClosing Window Optional. a GlossaryGlossary Glossary System Trouble Error Codes Following Statement is Required by the FCC Napco Limited Warranty