Napco Security Technologies GEM-DXRP2 manual Setting the Alarm Arming When Leaving

SETTING THE ALARM ( ARMING) WHEN LEAVING

		READY
	A C O N
		FAULT/
	A C O N	ZONE 02
		READY
B Y P A S S E D	A C O N
		EXIT/
	A C O N	XX SEC

Arming the System

Note: The keypad will autoscroll messages that are longer than one line.

1Check the keypad. The green STATUS light must be on in order to arm. If the green light is off, “FAULT” will display in the window followed by the number of each faulted zone. Note each problem zone and secure it by closing a window, door, etc. When all zones are secure, the green STATUS light will turn on and the

window will display “READY”.

Z O N E S F A U L T E D

Bypass faulted zones. If you cannot locate or repair the problem yourself, call

for assistance. If you cannot get immediate help, bypass the problem zone(s)

from the system by pressing B, then the zone number (or vice versa). Note:

0 2 B A C K D O O R

Bypassed zones are unprotected. If armed with zones bypassed, be sure to have the system checked as soon as possible.

2	Arm theBYPASSEDsystem. Enter your code and press J. The green STATUS light will go
		B Y P A S S E D
	off, the red ARMED light will turn on and the window will alternately display “EXIT"
	and "XX SEC" (where “XX” represents the exit time remaining, in 10-second
	steps). Note: If you enter an invalid code, the keypad will display “Wrong Code”.
3	BYPASSED	0 2 B A C K D O O R
	Leave the premises. Leave through the exit door before exit time expires.

6