Monarch 9494 manual Reloading a Ribbon Cassette

Page 16

9494 Operator's Handbook

Reloading a Ribbon Cassette –––––––––––––––––––––––––––––––––

To reload your ribbon, remove the ribbon cassette from the printer and follow these steps:

1.Locate the end of the cassette with the two latches.

Locate the International Symbols for opening and closing.

( )indicates the cassette is locked (closed). ( )indicates the cassette is unlocked (open).

2.Rotate both latches until they snap into the unlocked position.

3.Lift off the half of the cassette without the latches and set it aside.

Take-up

ReelRibbon

Roll

Ridged End of	Spool
Take-up Reel	Spool
	Foam
Latch	Washer
Latch
Gear	Latch

4.Remove the used ribbon and take-up reel and discard. Open a package of new ribbon.

2-4

Image 16

Contents Operators Handbook Canadian D.O.C. Warning Preface AudienceContinuous mode Terms to KnowTable of Contents Specifications and Accessories Label Sizes Cable Pin Outs Power Supply ChapterConnecting the Power Cord Installation Connecting the Communications Cable Communication Values Page Loading Ribbon and Supplies Pull the label guide forward and down as shown Loading Ribbon Reloading a Ribbon Cassette Loading Ribbon and Supplies Loading Supplies Loading for Peel Mode Operators Handbook Label Guide LED Loading for Non-Peel Mode Operators Handbook Label Guide Upper Opening Rear View Close the printer Printing in On-Demand Mode PrintingPrinting in Continuous Mode Canceling a Print JobInterrupting a Print Job Operators Handbook Care and Maintenance Clearing Label Jams Cleaning Let the printer dry and reload your supplies Troubleshooting Printing a Test LabelOperators Handbook LED Indicator Problems and Solutions Problem SolutionTroubleshooting Operators Handbook Specifications and Accessories SpecificationsAccessories Label SizesCable Pin Outs Operators Handbook Page Printedin U.S.A