Monarch 9494 manual Loading Ribbon

Page 15

Chapter 2. Loading Ribbon and Supplies

4.To close the printer, push the printhead assembly toward the front of printer, close the label guide and latch the face plate into place.

Loading Ribbon–––––––––––––––––––––––––––––––––––––––––––––

Use ribbon only when printing on thermal transfer labels.

To load the ribbon cassette into the printer:

1.Open the printer and remove the ribbon cassette.

2.Slide a new ribbon cassette onto the printhead assembly until it slips into place.

Ribbon Cassette

Printhead Assembly

3.Close the printer.

Make sure the ribbon is wound tightly inside the cassette before you close the printer. See "Reloading a Ribbon Cassette" to wind the ribbon.

2-3

Image 15

Contents Operators Handbook Canadian D.O.C. Warning Audience PrefaceTerms to Know Continuous modeTable of Contents Specifications and Accessories Label Sizes Cable Pin Outs Chapter Power SupplyConnecting the Power Cord Installation Connecting the Communications Cable Communication Values Page Loading Ribbon and Supplies Pull the label guide forward and down as shown Loading Ribbon Reloading a Ribbon Cassette Loading Ribbon and Supplies Loading Supplies Loading for Peel Mode Operators Handbook Label Guide LED Loading for Non-Peel Mode Operators Handbook Label Guide Upper Opening Rear View Close the printer Printing Printing in On-Demand ModeCanceling a Print Job Printing in Continuous ModeInterrupting a Print Job Operators Handbook Care and Maintenance Clearing Label Jams Cleaning Let the printer dry and reload your supplies Printing a Test Label TroubleshootingOperators Handbook LED Indicator Problem Solution Problems and SolutionsTroubleshooting Operators Handbook Specifications Specifications and AccessoriesLabel Sizes AccessoriesCable Pin Outs Operators Handbook Page Printedin U.S.A