Monarch 9494 manual Connecting the Power Cord

Page 8

9494 Operator's Handbook

Connecting the Power Cord ––––––––––––––––––––––––––––––––––

Before you plug or unplug the power cord, turn the printer off.

To connect the power cord:

1.Turn the printer off. (I) indicates on and (O) indicates off.

2.Turn the printer as shown.

3.Insert the power cord into the socket as shown below.

Power Cord

Socket

4.Plug the other end of the power cord into a grounded electrical outlet of the correct voltage.

WARNING: The power supply cord is intended to serve as the disconnect device. The socket-outlet shall be near the equipment and shall be easily accessible.

1-2

Image 8

Contents Operators Handbook Canadian D.O.C. Warning Preface AudienceContinuous mode Terms to KnowTable of Contents Specifications and Accessories Label Sizes Cable Pin Outs Power Supply ChapterConnecting the Power Cord Installation Connecting the Communications Cable Communication Values Page Loading Ribbon and Supplies Pull the label guide forward and down as shown Loading Ribbon Reloading a Ribbon Cassette Loading Ribbon and Supplies Loading Supplies Loading for Peel Mode Operators Handbook Label Guide LED Loading for Non-Peel Mode Operators Handbook Label Guide Upper Opening Rear View Close the printer Printing in On-Demand Mode PrintingPrinting in Continuous Mode Canceling a Print JobInterrupting a Print Job Operators Handbook Care and Maintenance Clearing Label Jams Cleaning Let the printer dry and reload your supplies Troubleshooting Printing a Test LabelOperators Handbook LED Indicator Problems and Solutions Problem SolutionTroubleshooting Operators Handbook Specifications and Accessories SpecificationsAccessories Label SizesCable Pin Outs Operators Handbook Page Printedin U.S.A