Monarch 9494 manual Led

Page 22

9494 Operator's Handbook

7.Close the printer.

Make sure the ribbon is wound tightly inside the ribbon cassette before you close the printer. See "Reloading a Ribbon Cassette" to wind the ribbon.

Upper

Opening

Label

Guide

Lower

Opening

8.Turn the printer on.

9.Wait until the LED flashes one time (about five seconds) and then press the trigger. The printer calibrates the label strip for printing. When you print, labels peel automatically through the upper opening in the label guide and the backing paper exits out the lower opening.

Trigger

LED

The LED slowly alternates flashing amber and green to indicate the printer is out of labels. When this happens, load a new roll of labels and press the trigger to clear the error.

2-10

Image 22

Contents Operators Handbook Canadian D.O.C. Warning Preface AudienceContinuous mode Terms to KnowTable of Contents Specifications and Accessories Label Sizes Cable Pin Outs Power Supply ChapterConnecting the Power Cord Installation Connecting the Communications Cable Communication Values Page Loading Ribbon and Supplies Pull the label guide forward and down as shown Loading Ribbon Reloading a Ribbon Cassette Loading Ribbon and Supplies Loading Supplies Loading for Peel Mode Operators Handbook Label Guide LED Loading for Non-Peel Mode Operators Handbook Label Guide Upper Opening Rear View Close the printer Printing in On-Demand Mode PrintingPrinting in Continuous Mode Canceling a Print JobInterrupting a Print Job Operators Handbook Care and Maintenance Clearing Label Jams Cleaning Let the printer dry and reload your supplies Troubleshooting Printing a Test LabelOperators Handbook LED Indicator Problems and Solutions Problem SolutionTroubleshooting Operators Handbook Specifications and Accessories SpecificationsAccessories Label SizesCable Pin Outs Operators Handbook Page Printedin U.S.A