Monarch 9450 manual About Sleep Mode, Loading the Battery

Page 14

9450 Operator’s Handbook

2.Squeeze the side tabs on the battery and pull the battery away from the printer.

Loading the Battery

To load the battery:

1.Insert the bottom tabs on the battery into the slots at the bottom of the battery well.

2.Push the top of the battery onto the prongs until the battery snaps into place.

About Sleep Mode ––––––––––––––––––––––––––––––––––––––––––

When the printer is inactive for a certain period, it goes into sleep mode to conserve battery power. During sleep mode, the printer retains all print jobs, but isn’t operational.

See your System Administrator to set the time the printer waits before going into sleep mode. The default is 2 minutes, but it can range from 10 seconds to 2.7 hours. Your System Administrator can also disable sleep mode entirely. If sleep mode is disabled, an F appears on the test label before the delay time.

To recover from sleep mode, press [On/Off]. The printer takes 100 milliseconds to recover.

nDo Not send a print job during this interval. It will be lost.

1-6

Image 14
Contents Monarch Rascal Printer Canadian D.O.C. Warning Preface Terms to Know ParametersSleep Mode Operator’s Handbook Table of Contents Operator’s Handbook Chapter Getting Started Using the Buttons FeedCharging the Battery On/OffSocket Small Round Connector Removing and Loading the Battery Getting StartedAbout Sleep Mode Loading the BatteryAttaching the Belt Operator’s Handbook Chapter Loading Supplies Loading for Peel Mode Loading Supplies On/Off Button Supply Guide Support Frame Holder Knob Supply Chute Support Frame Backing Paper Label Loading for Non-Peel Mode Supply Guide Knob Leading Edge Well Removing Supplies Setting Communications Parameters Printer CommunicationsPress Feed once. The LED indicator blinks once Connecting the Communications Cable Printer CommunicationsRemoving the Communications Cable Printing in On-demand Mode Chapter PrintingRemoving Backing Paper Printing in Continuous ModePausing the Printer Clearing a Print JobCare and Maintenance Clearing JamsJammed Label Supply Supply Chute Guide Inserting the Supply Guide Cleaning the Printhead VoidsCleaning the Platen Roller and Peel Blade Let the printer dry briefly. Then, reload your supplies Chapter Troubleshooting Printing a Test LabelLED Indicator LED Indicator StatusProblems and Solutions Problem SolutionOperator’s Handbook Problem Solution Operator’s Handbook Chapter Specifications Printer SpecificationsAccessories Supply SizesPin Signal Direction Communications Cable Pin DefinitionsOperator’s Handbook Index Page Using the buttons Weight of printer Width of printer Page Toll Free