Monarch 9450 manual Problem Solution

Page 41

 

 

Chapter 6. Troubleshooting

 

 

 

 

 

 

 

Problem

Solution

 

 

 

 

Printer does not print.

Charge the battery.

 

 

 

 

 

Make sure the print job was correct.

 

 

 

 

 

Make sure the supplies are loaded

 

 

correctly.

 

 

 

 

 

Make sure the printhead is closed.

 

 

 

 

Printer does not start.

Make sure the battery is charged and

 

 

plugged into the printer.

 

 

 

 

 

Make sure the printhead is closed.

 

 

 

 

Slow or sluggish feeding.

Make sure the supplies are loaded

 

 

correctly.

 

 

 

 

 

Make sure no foreign matter is in the

 

 

supply spool.

 

 

 

 

 

Make sure the supply turns freely in

 

 

the supply well.

 

 

 

 

 

Check for adhesive buildup in the

 

 

feed path and on the peel blade.

 

 

 

If you continue to have problems:

FRemove the battery, wait a few seconds and re-connect it while pressing [On/Off].

FMake sure the battery is fully charged.

FCall Monarch at the number at the back of this manual.

6-5

Image 41
Contents Monarch Rascal Printer Canadian D.O.C. Warning Preface Parameters Terms to KnowSleep Mode Operator’s Handbook Table of Contents Operator’s Handbook Chapter Getting Started Feed Using the ButtonsOn/Off Charging the BatterySocket Small Round Connector Getting Started Removing and Loading the BatteryLoading the Battery About Sleep ModeAttaching the Belt Operator’s Handbook Chapter Loading Supplies Loading for Peel Mode Loading Supplies On/Off Button Supply Guide Support Frame Holder Knob Supply Chute Support Frame Backing Paper Label Loading for Non-Peel Mode Supply Guide Knob Leading Edge Well Removing Supplies Printer Communications Setting Communications ParametersPress Feed once. The LED indicator blinks once Printer Communications Connecting the Communications CableRemoving the Communications Cable Chapter Printing Printing in On-demand ModePausing the Printer Printing in Continuous ModeRemoving Backing Paper Clearing a Print JobClearing Jams Care and MaintenanceJammed Label Supply Supply Chute Guide Inserting the Supply Guide Voids Cleaning the PrintheadCleaning the Platen Roller and Peel Blade Let the printer dry briefly. Then, reload your supplies Printing a Test Label Chapter TroubleshootingLED Indicator Status LED IndicatorProblem Solution Problems and SolutionsOperator’s Handbook Problem Solution Operator’s Handbook Printer Specifications Chapter SpecificationsSupply Sizes AccessoriesCommunications Cable Pin Definitions Pin Signal DirectionOperator’s Handbook Index Page Using the buttons Weight of printer Width of printer Page Toll Free