9450 Operator’s Handbook
If the battery loses power in the middle of a printing session, replace or recharge the battery. The printer remembers the print job.
When you use or store your charger, do not:
Fwrap the cord around the charger.
Fpull or put unusual stress on the cord.
wBefore using the charger, inspect the cord for bare wires. Do Not use a charger with bare wires. Only use a charger approved for use with this printer.
To charge the battery:
1.Remove the battery, as described in "Removing the Battery."
2.Plug the small, round connector on the charger cord into the socket on the battery, as shown. The charger’s LED indicator is solid amber when the charger is fully connected.
Socket
Small Round
Connector
3.Plug the charger into a 115V electrical outlet. A full initial charge takes approximately 14 hours.
nAreas using 220V or 240V electrical outlets will receive a charger designed for these voltages. See Chapter 7, "Specifications," for information.