Matsushita CF-18NHHZXBM Assembly of Touch Screen Applicable Model Touch Screen Model

!Assembly of Inverter PCB (Applicable Model : Digitizer Model) Safety Working

Avoid any stress on the Cable

Inverter Assy

LCD Rear Side

	when connecting it to the Inverter.
Avoid any stress on the Cable	(Hold the Connector part
	when connecting/disconnecting.)

	when connecting it to the Inverter.
	(Hold the Connector part					LCD Side Cushion E
	when connecting/disconnecting.)		LCD Side Cushion F
						Insert between the ribs.
LCD Side Cushion E			Insert between the ribs.
Insert between					Caution High Voltage Label
the ribs.
						0~3mm
	Tape			Inverter Assy
	Attach	so the Inverter Assy
				Connect the Cable to the left
	comes at the center.
				and right Connectors.
	(Top/Bottom: -2 to +2 mm,
	Left/Right: -3 to +3 mm)

Pay attention to the direction of the INVERTER PCB when doing this installation.

Inverter
Case MIL	INV MIL Cover
5~6mm
LCD Cable	Insert
Connector side
INV Sheet 1 Inverter	Insert
(Black)

Detail of "A"

Safety Working

Confirm a

"ANT Cable Cushion"

isn’t frayed.

Carefully attach Tape.	Tape
Inverter Assy
LCD Back Dumper

Sield Sheet		LCD Cable
	pasted on the connector		Safety Working
	after it is wound around
	the cable twice.	Insulation Parts

Avoid getting under the Sheet.

A6–2mm from the branch point

0~0.5mm
PET Tape2
Match to the
left end of	0~0.5mm
the square
hole of the
Connector.
0~3mm

5~6mm

INV Sheet 2(Translucence)

CCFL Connector side

1~2

mm

Don’t give stress to LCD TAB.	ANT Cable Cushion	Conductive Tape
Avoid any stress on the TAB	Wrap.
part of the LCD Module.		Wrap over the Antenna Cable
		Cushion and the Cable.

!Assembly of Touch Screen (Applicable Model : Touch Screen Model)

		A		Detail of "A"
		Touch Screen Assy	Back side
		Protect Sheet	6–0.5mm
Remove it parallel to the Touch Screen.				TS FPC
OK	Laminate film	Attach the surface
		at the center of		Spacer
		the display.
		(Using the jig)
	Touch Sreen	Dimensional tolerance
NG		:–0.2
	Laminate film			0~0.5mm
	Touch Sreen		Touch
				0~0.5mm
			Screen
				Place this to the wall of cabinet.
		TS Spacer A

Attach the surface to the LCD Front.

Be free of overhang..

Touch Screen Assy

0~1mm	0~1mm
TS Spacer B	TS Spacer B
TS Spacer A /TS Spacer B:
Don’t get into a LCD indication range.

TS Spacer A

0~1mm

0~1mm

–0.5mm

Fit this to the line of cabinet.

LCD Side Cushion B

–0.5mm

Fit this to the line of cabinet.

7-9