Matsushita CF-18NHHZXBM Setting up the LCD Hinge, Assembly of LCD Hinge, Cable Hold Plate ScrewY

7.2.4.Setting up the LCD Hinge

1.Wind the Cable coming out of the LCD Unit conterclock- wise to the LCD Hinge.

2.Set the Lock Plate and the Hinge Top Cover, and rotate the LCD Hinge to turn the Display Unit to front

3.Put the LCD Cable and the Antenna Cable in the Cable Holder.

4.Fit another Cable Holder and clamp the Cable Holders in the LCD Hinge.

5.Fix the LCD Hinge using the 2 Screws <Y> and the 2 Cable Holder Plates.

Screws <Y> : DXYN3+J8FNL

!Assembly of LCD Hinge

Cable	<Y>
Holder	<Y>	Cable
Plate
		Holder
LCD		Plate
Hinge		Cable
		Holder
Cable Holder		LCD Cable
		Holder
Plate		Sheet
		Cable
		Holder

Safety Working

Ensure it comes

over the Cable Hold Tape. Not necessary if the Cable is not passed under

the Cable Hold Plate.

Cable Hold Plate

A	Screw<Y>
	LCD Hinge

Ensure the "C" side comes to the lower right corner when viewing from above.

	Safety Working	A
Screw<Y>	Avoid catching the Cable.
	Be free of pinching cables.

Avoid running over

Cable Hold Plate the Hinge and the rib.

Initial condition of LCD Hinge.

The direction which can rotate

Using the fixing jig when fixing the Hinge

Tighten.Tighten.

Fix.

If you arrange the Cable in the area, you do not need to use the fixing jig.

Avoid catching the Cable (when repairing or when not using the jig). Temporarily fix the both sides ("A") of the Hinge using

the Screw <W>, and fix the Cable Hold Plate.

After fixing the Cable Hold Plate, remove the Screw <W> from the both sides ("A").

Cable Hold Plate is installed after it is kept in A temporarily.(using Screw<W>)

7-12