Matsushita CF-18NHHZXBM Putting of the Palm Rest Assy, Keyboard KBD Tape, Screw Screw Screw

!Cautions for Setting the Keyboard

LCD CABLE

Connect the Connector to the part with dotted frame.

(Note

Hold the Connector part when connecting/disconnecting. Do not bend at the foot

of stiffening plate.)

Touch Panel model

Keyboard

	Keyboard
KBD Tape
Lengthwise:	KBD Tape	KBD Tape
Match to the center line.
Crosswise:		Lengthwise:
Match to the end of the KBD.		Match to the center line.
8~		Crosswise:
		Match to the end of the KBD.
10mm	KBD Tape
		0~1mm
0~1mm

Lengthwise: Match to the top end of the KBD.

Push the Cushion of the jig into the part with dotted frame ("A"),

and press on the jig until the both ends of jig fit to the Top Case ("B").

KBD Connector Cover
Apply the load to attach. 30 to 40N
(3.0 to 4.0 Kgf)	KBD Connector Cover
0–0.5mm
KBD Connector Cover Sheet

Connector for the KBD FFC. Digitizer Model

A B

B

Screw

Screw Screw

Jig HINGE COVER

KBD CNT LID CUSHION

Screw

Connector for the KBD FFC.

Safety Working

Screw

KBD Connector Cover

Set it and then press it using the jig.	KBD Plate(L)	Screw
	Fix from the
(Insert the Hook first.)
	Hinge side.

Screw

Before setting the KBD Plate (L)

Connect the KBD FFC.and the KBD Plate (R), press on the positions (four) with the two-sided tapes. 30N(3.0Kgf)

KBD Plate(R)

Fix from

the Hinge side.

!Putting of the Palm Rest ASSY

3~5mm
Windows Logo Label	intel Label

5~7mm

3~5mm

4~6mm

Energy Star Label

Remove the Release Paper, and then attach the Palmrest Assy.

Remove the two-sided tape on the back side and attach it.

Attach and apply the load 30 to 40N (3.0 to 4.0 Kgf).

Palm rest Assy

Release Paper

LED Waterproof Sheet Set the four Hooks.

Match to the upper left corner. 0 to 0.3 mm Avoid running over when attaching.

Don’t overflow.

7-32