Matsushita CF-29N3LGZBM manual Setting the Handle and Power SW

7.2.6.Setting the Handle and Power SW

1.Set the Power SW.

2.Set the Handle.

3.Fix the Handle Base Land R using the two Screws<g>.

Screws <g>: DRSB4+8FKL

<g>

Handle Base L

Power	<g>
SW	Handle

Handle Base R

7.2.7.Setting the Palm Top Cover Sheet, Palm Top Cover, Touch Pad Adhesion Seat, Touch Pad, Touch Pad SW Knob, LED PCB and SW LED PCB

1.Set the SW LED PCB.

2.Attach the Power LED Packing Sheet to the LED Spacer Sheet.

3.Attach the LEDX6 Spacer Sheet on the SW LED PCB.

4.Fix the SW LED PCB using the Screw<f>.

5.Attach the PW LED Sheet.

6.Pass the Cable of LED PCB through the hole 1 on the Top Cabinet, then set the LED PCB.

7.Attach the LED Spacer Sheet on the LED PCB

8.Set the Touch Pad SW Knob In and Touch Pad SW Knob.

9.Attach the TP Bottom Tape to the Touch Pad.

10.Pass the Cables of the Touch Pad through the hole 2 on the Top Cabinet, set the Touch Pad.

11.Attach the Touch Pad Adhesion Seat.

12.Fix the Palm Top Cover using the five Screws<e>. No1 to No5

13.Attach the Palm Top Cover Sheet.

Note:

Tighten the Screws in the numbered order (No1 to No5).

Screws <e>: DRHM0002ZA

Screw <f>: DRHM0002ZA

Palm Top Cover Sheet

	<e>
	:No2 <e>	:No3<e>
<e>	<e>:No1
	:No5
:No4
		Palm Top Cover
				PW LED Sheet
		Touch Pad	<f>	LED Spacer
		Adhesion Seat		Sheet
				Power LED
Touch Pad		Touch Pad		Packing Sheet
SW Knob				SW LED PCB
LEDX6
Spacer		Cable
Sheet
LED PCB		TP Bottom
Cable		Tape		Tape CPU
		Power SW
FCC CN		PCB Cushion
Stopper	Touch Pad
	SW Knob In

Hole 1

Top Cabinet

Hole 2

7-18