Operation of skip channel function | Sanyo ECD-T1560 specs

SIRIUS MODE SELECTION .........….............…….…..(5)

Press LOC/S-MODbutton (5) to switch Category mode, Skip mode or normal. It is used as the selection of each:

Normal		Category mode		Direct Tune		Skip Channel mode

When Category mode or Skip mode is engaged, the “CATEGORY” or “SKIP” function is turned on in the display. When Category mode or Skip mode is released, the “CATEGORY” or “SKIP” function is turned off. When Direct mode is engaged, “DIRECT” of alphanumeric display is turned on.

Select Category and TUNE UP/DOWN within selected Category

Use CAT/DIR button (7) or CAT/DIR button (6) to select desire Category and press BAND/LOUD/ENT button (2).

In Category mode, stations can be tuned within the same category.

-When the user wishes to search by Category, press LOC/S-MODbutton (5) can be pressed until it goes into Category search mode.

-Press CAT/DIR button (7) or CAT/DIR button (6) up and down to get to the desired category.

-To change channels, press LOC/S-MODbutton (5) again to Normal mode, and then press

MANU/SKIP/CH or button (3) to select the channel up or down.

The operation of skip channel function

In Skip mode, pressing LOC/S-MODbutton (5) for more than 3 seconds sets the SKIP channel mode. Details for set or release skip channel is as follows.

Use MANU/SKIP/CH or button (3) to be switched to SKIP channel set or release mode sequentially.

-Press BAND/LOUD/ENT button (2) to select skip or release the following channel. (If the channel was skipped, the “SKIP” icon will be displayed.

-Press LOC/S-MODbutton (5) for more than 3 seconds again to return to basic mode automatically after 10 seconds.

Note:

In skip mode, use MANU/SKIP/CH or button (3) to show skipped channels.

How to direct tune

1.In direct mode, display shows DIRECT and “000” channel number. (Hundred Digit flashing on/off)

2.Use MANU/SKIP/CH or button (3) to select hundred digit.

3.Press LOC/S-MODbutton (5) again to confirm entry of the hundred digit and the 10s digit is flashing on/off.

4.Use MANU/SKIP/CH or button (3) to select 10s digit.

5.Press LOC/S-MODbutton (5) again to confirm entry of the 10s digit and the 1s digit is flashing on/off.

6.Press LOC/S-MODbutton (5) again to confirm entry of the 1s digit.

7.Press BAND/LOUD/ENT button (2) to direct tune.