Minuteman UPS PRO-E user manual English

Page 6

English

On-Line/On-Battery/Boost/Buck LED

Fault LED

Overload LED

Weak/Bad Battery LED

On/Off/Test Button

Press and release the ON/OFF/Test Button after 1 beep to turn the UPS ON or OFF (see section 4).

On-Line

On-Battery

Buck Boost

The On-Line/On-Battery/Boost and Buck (green) LED illuminates in a steady state when the UPS is on and supplying AC power to the load. The LED blinks and the audible alarm sounds, when supplying battery power to the load. The LED blinks and no audible alarm when the UPS is in either the boost or the buck mode.

The Fault (red) LED illuminates when the UPS has detected an inter- nal fault. (see section 5)

The Overload (yellow) LED illuminates when the loads connected to the UPS exceeds the UPS power rating. (see section 5)

The Weak/Bad Battery (red) LED illuminates when the UPS has detected that the batteries are Weak/Bad. Battery replacement might be required. (see section 5)

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents PRO-E Series English Important Safety Instructions Authorized Service Personnel only Receiving Inspection English Rear Panel 120V ModelsInstallation Placement InstallationConnecting Your Equipment Charging the Battery Connecting the UPS to AN AC SourceChecking the Site Wiring Fault Communications Port Connection OptionalDIP Switch Settings Turning the Unit ON/OFFSelf Test WEAK/BAD Battery Alarms On BatteryLOW Battery Warning UPS FaultCommunications Ports RS232 and USB If the AC circuit breaker trips Replacing the Battery Authorized Service Personnel onlyBattery Replacement Procedure PRO-E PRO500E PRO700EEnglish If the UPS Requires Service Model Number PRO500E PRO700E EPO English Limited Product Warranty Robert Calhoun Declaration of ConformityEnglish PN 34000226 Rev
Top Page Image Contents