d.During the process of the installation, a message “Windows can’t verify the publisher of this driver software” might be prompted. Please ignore it, and click on [Install this driver software anyway] to continue the installation without any misgiving at your scanner functioning.
5.When the system completes the installation, click on the “Finish” button.
6.Follow the
7.After the software is installed, close all open applications and click on the “Finish” button to restart your computer.
8.After the computer is restarted, you will be prompted to perform the scanner calibration.
9.Insert the special calibration sheet, included with the scanner, face up into the page feed of the scanner.
10. Follow the
Attention
If the scanner installation is not started and displayed automatically on the screen, click “START”, select “Run” and type in “D:\Install” (where D: is the drive letter assigned to the CD- ROM drive of your computer.)
Alternatively you may also use any plain white sheet of paper sized in A6 (105 x 148 mm) instead; however, the calibration effect may be less good than the special calibration sheet.
Step 3. Testing the Scanner
The following test procedure checks to see if the scanner is properly functioning with your computer and the scanning software. Before testing your scanner, double check to make sure that all connections are securely fastened.
To properly test your scanner, please perform the following steps:
1. Do one of the following to open the Button Configuration window:
in the Windows system tray.
9