Magma CB1F manual Click . Your computer will6ORWreboot.6HULHV8VHUV0DQXDO

0$*0$

NOTE

Prior to installing the MAGMA CardBus Driver, you should be familiar with the installation procedures for the PCI cards that you are installing in the expansion chassis. Some PCI card manufacturers recommend that you install their software driver(s) prior to installing the hardware. If this is the case, you should install their driver before you connect and power up the expansion chassis. You may be required to reboot before connecting the expansion chassis.

NOTE

Under Windows XP, you MUST connect the MAGMA expansion chassis to your computer BEFORE installing the MAGMA CardBus Driver.

MAGMA CardBus Drivers are required for Windows XP. Follow the Step-by-Step Instructions included in Chapter Two: Quick Start Guide prior to installing the MAGMA CardBus Driver. It is important to apply power to the expansion chassis first, and then apply power to your computer.

WARNING

You must be logged in as ‘System Administrator’ while installing the MAGMA expansion chassis. You must remain logged in as ‘System Administrator’ until installation Is complete.

The first time your system boots up, with the expansion chassis connected, the following System Settings Change Window will appear:

Click . Your computer will￿6ORWreboot.6HULHV8VHU￿V0DQXDO ￿￿

WARNING

Although you have not installed the MAGMA CardBus Driver yet, it is important that you answer ‘Yes’ to the above question and restart your computer.