Magma CB1F manual Verify Installation

0$*0$

You should now Shut down the computer. This means, Turn off your computer completely.

After you have Shut down completely, connect the expansion chassis to your computer by following the Step-by-Step Instructions included in Chapter Two: Quick Start Guide. It is important to apply power to the expansion chassis first, and then apply power to your computer. As your system comes back up, several New Hardware Found Windows will appear. The first Window will display: DEC Bridge PCI to PCI 21152 found and a second Window will display: DEC Bridge PCI to PCI 21150 found.

If PCI cards are installed in the expansion chassis, you may be prompted to load or locate drivers. Follow the instructions you see on the screen and install the drivers just as you would on a desktop computer. (You should refer to the procedures for installing drivers that was included with the third-party PCI device(s) you are installing.) If prompted to reboot, do so.

Verify Installation

Go to ·Start ￿Settings ￿Control Panel ￿System ￿Device Manager (make sure ‘View device by connection’ is chosen) ￿Open ACP (BIOS) ￿Open PCI Bus ￿Click the ‘+’ sign several times until your reach the DEC Bridge 21150 PCI to PCI Bridge. Under this entry you should see any hardware that￿6ORWis installed6HULHVin8VHUthe￿Vexpansion0DQXDOchassis￿￿. (In the following example, there is a CMD IDE Controller and IDE disk drive installed in the expansion system.)