Nordic Star Products 4.3A manual Receiveonly, Resolution, Reversestats, Roundrobin

Keyword reference

Indicates that client programs should be quiet and not write information onto the screen as standard. For example this is equal to calling faxsend with the argu- ment -q.

15.1.67 RECEIVE_ONLY

RECEIVE_ONLY

Indicates that fax lines should be used only for receiving. This function is also controlled by the scope of your license agreement. If the fax modem is used for incoming modem traffic and outgoing fax traffic SEND_ONLY must be given, otherwise the fax server will try to answer and receive incoming calls as a fax.

15.1.68 RESOLUTION

RESOLUTION=HIGH LOW

Gives the standard resolution of the faxes that are sent out. Note that if the fax called does not support high resolution then low resolution is negotiated. Possi- ble values are HIGH or FINE for high resolution and LOW or STANDARD for low resolution.

A high-resolution fax is precisely twice as large as a low-resolution fax and takes twice as long to send (approx. 1 minute for an A4 page).Standard value: HIGH (high resolution)

15.1.69 RETRY_TIME

RETRY_TIME=minutes

Indicates at what minute intervals attempts should be made to send a fax that is not successfully sent.

15.1.70 REVERSE_STATS

REVERSE_STATS

Indicates that statistics lists (sent and failed faxes) should be shown in reverse order, i.e. with the most recent fax first.

15.1.71 ROUND_ROBIN

ROUND_ROBIN

When using multiple fax devices with XFAX the standard behavior is to always use the first available line for transmission so if FAXLINES=tty00:tty01, tty00 is always picked if available. By using this keyword fax lines are always used in sequential order. That is, first tty00 is used then tty01, tty00 and so on. This is really the best way to minimize non-successful attempts if a fax device should break down.

15.1.72 SEND_BPS

SEND_BPS

XFAX - User’s Guide 4.3a 54