Quantum Audio Scalar 50 installation instructions Completing the Native Fibre Channel Installation

Page 14
Completing the Native Fibre Channel Installation

Quantum Scalar 50 Tape Drive Installation Instructions

Document 81-81769-01 B01

September 2007

6To change a SCSI ID, enter the ID number in the field next to the device and click Apply.

7From the Operations page, click on the Drives tab. The Drives page displays (see figure 15):

Figure 15 Drives Page

Drive operationsManual background

8Enter the new tape drive number

9Select shutdown and click Apply. The tape drive powers down.

10Enter the new tape drive number

11Select Power on and click Apply.

The tape drive powers on. The tape drive installation is complete.

Note: The firmware revision on the new tape drive(s) must match the firmware revision on the currently installed tape drives (of the same tape drive type). If the new tape drive has a different revision, you must download the appropriate tape drive firmware from Quantum and update the drive. All tape drives in the library must contain the same firmware revision. You can view the tape drive firmware revision on the OCP under Drive Operations.

Completing the Native Fibre Channel Installation

After native Fibre Channel tape drives are installed, additional information must be gathered to complete the installation and verify connectivity. Competing the native Fibre Channel tape drive installation consists of the following steps:

14

Completing the Native Fibre Channel Installation

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Quantum Scalar Tape Drive Installation Instructions COPYRIGHT STATEMENT Quantum Scalar 50 Tape Drive Installation InstructionsDocument 81-81769-01 B01 September TRADEMARK STATEMENTCabling the Tape Drives Setting the Tape Drive SCSI ID IntroductionUnpacking the Tape Drive Installing the Tape Drives Completing the Native Fibre Channel InstallationTable 1 Tape Drive Upgrade Kits SDLT Scalar 50 Tape Drive Upgrade KitsFigure 2 Scalar 50 Cable Configuration Half-Height Drives SDLT Part NumberNumber LTO PartPC-KUCQA-YF LTO-3 HH SCSI, single drive PC-KUC1A-YF LTO-3 HH SCSI, dual driveRequired Tools Installing the Tape DrivesUnpacking the Tape Drive Cabling the Tape Drives Proceed to Cabling the Tape DrivesFibre Tape drives Figure 7 Scalar 50 Cable Configuration Native FibreChannel Half-Height Drives Scalar 50 slave library Configuration StackedDocument 81-81769-01 B01 September Figure 8 Scalar 50 Cable Host computerSetting the SCSI ID Using the OCP Setting the Tape Drive SCSI IDSetting the SCSI ID Using the OCP Setting the SCSI ID from the Remote Management PagesSetting the SCSI ID from the Remote Management Pages 3 Enter the username and password and click OK Completing the Native Fibre Channel Installation Determining the WWNs World Wide Names Verifying Library Connectivity Using the Remote Management to Determine the WWNsDetermining the WWNs World Wide Names Library/Tape Drive World Wide Name e.gFigure 17 Setup Page 4 Click Setup from the contents frameThe management frame displays the Setup page see figure 5 Click on the SCSI/Fibre tab The SCSI/Fibre page displays see figureWorld wide name typeTape drives Media changerConnect Via a Telnet Session Verifying LibraryConnectivity Connect Via a Web Browser Connect Via a Telnet SessionSCSI ID Assignment with Native Fibre Channel Tape Drives Fibre Channel Connectivity TroubleshootingConnect Via a Web Browser SCSI ID Assignment with Native Fibre Channel Tape Drives To display the SCSI ID assignments Document 81-81769-01 B01 September 81-81769-01 B01 81-81769-01 B01
Top Page Image Contents