Quantum Audio Scalar 50 installation instructions Proceed to Cabling the Tape Drives

Page 7

Quantum Scalar 50 Tape Drive Installation Instructions

Document 81-81769-01 B01

September 2007

3Insert the tape drive into the drive bay slowly until the connectors are seated (see figure 3).

4Tighten the tape drive captive screws using a flat blade screwdriver.

5Repeat steps 1 through 4 to install another tape drive in a different location, if desired.

Figure 3 Installing a Tape

Drive

Tape drive 1

Captive screw

Tape drive 2

Captive screw

Proceed to Cabling the Tape Drives.

Cabling the Tape Drives

After the tape drive(s) have been installed, you must connect SCSI or Fibre

Channel cables to each drive.

Refer to the following figures to cable the tape drives:

•Figure 4 SCSI full height drives

•Figure 5 Native Fibre Channel full height drives

•Figure 6 SCSI half-height drives

•Figure 7 Native Fibre Channel half- height drives

•Figure 8 Stacked Library Configuration

Cabling the Tape Drives

Image 7

Contents Quantum Scalar Tape Drive Installation Instructions TRADEMARK STATEMENT Quantum Scalar 50 Tape Drive Installation InstructionsDocument 81-81769-01 B01 September COPYRIGHT STATEMENTCompleting the Native Fibre Channel Installation IntroductionUnpacking the Tape Drive Installing the Tape Drives Cabling the Tape Drives Setting the Tape Drive SCSI IDSDLT Part Number Scalar 50 Tape Drive Upgrade KitsFigure 2 Scalar 50 Cable Configuration Half-Height Drives Table 1 Tape Drive Upgrade Kits SDLTPC-KUC1A-YF LTO-3 HH SCSI, dual drive LTO PartPC-KUCQA-YF LTO-3 HH SCSI, single drive NumberUnpacking the Tape Drive Installing the Tape DrivesRequired Tools Proceed to Cabling the Tape Drives Cabling the Tape DrivesFibre Channel Half-Height Drives Figure 7 Scalar 50 Cable Configuration Native FibreTape drives Host computer Configuration StackedDocument 81-81769-01 B01 September Figure 8 Scalar 50 Cable Scalar 50 slave librarySetting the SCSI ID from the Remote Management Pages Setting the Tape Drive SCSI IDSetting the SCSI ID Using the OCP Setting the SCSI ID Using the OCPSetting the SCSI ID from the Remote Management Pages 3 Enter the username and password and click OK Completing the Native Fibre Channel Installation Library/Tape Drive World Wide Name e.g Using the Remote Management to Determine the WWNsDetermining the WWNs World Wide Names Determining the WWNs World Wide Names Verifying Library Connectivity5 Click on the SCSI/Fibre tab The SCSI/Fibre page displays see figure 4 Click Setup from the contents frameThe management frame displays the Setup page see figure Figure 17 Setup PageMedia changer typeTape drives World wide nameConnectivity Verifying LibraryConnect Via a Telnet Session Connect Via a Telnet Session Connect Via a Web BrowserConnect Via a Web Browser Fibre Channel Connectivity TroubleshootingSCSI ID Assignment with Native Fibre Channel Tape Drives SCSI ID Assignment with Native Fibre Channel Tape Drives To display the SCSI ID assignments Fibre Channel Connectivity Troubleshooting 81-81769-01 B01 81-81769-01 B01