Quantum Scalar 50 Tape Drive Installation Instructions
Document
September 2007
Figure 11 Host Bus
Options Screen
Figure 12 Drive Operations Screen
Setting the SCSI ID from the Remote Management Pages
4Use the up and down arrows to highlight the tape drive receiving the new SCSI ID and press Enter.
5Use the up and down arrows to select a SCSI ID and press Enter to set the ID.
6When you have completed setting the SCSI IDs, press Exit to return to the
Cabinet screen.
7From the Ops screen, use the up and down arrows to highlight Drive Operations and press Enter.
The Drive Operations screen displays (see figure 12):
8Use the up and down arrows to select a tape drive and press Enter.
9Use the up and down arrows to select Off and press Enter.
The tape drive powers down and returns to the Drive Operations screen.
10Use the up and down arrows to select On and press Enter.
The tape drive powers on and is ready for use. The tape drive installation is complete.
To set the tape drive SCSI ID on a Scalar 50 Series library from the remote management pages:
Note: The library must be
1On the host computer, open the internet browser software.
2In the Address field, type http://IPaddress/ where IP address is the IP address for the Quantum Scalar 50 Series library.
12 | Setting the Tape Drive SCSI ID |